SP485E vs MAX485ESA+T Comparaison

Comparaison détaillée côte à côte de SP485E par MaxLinear et MAX485ESA+T par Analog Devices. Comparez les spécifications clés, les paramètres électriques, le conditionnement, le statut de cycle de vie, les prix et la disponibilité pour déterminer le meilleur composant pour vos exigences de conception.

Analog Devices
MAX485ESA+T MAX485ESA+T - 2.5Mbps RS-485/RS-422 Transceiver | ADI

MAX485ESA+T - 2.5Mbps RS-485/RS-422 Transceiver | ADI

MAX485ESA+T ✓ Actif

Comparaison des spécifications

Paramètre SP485E MAX485ESA+T
Marque MaxLinear Analog Devices
Catégorie Interface ICs Interface ICs
Statut du cycle de vie Actif Actif
Fonction Transceiver —
Protocol RS-485, RS-422 —
Number of Drivers/Receivers 1/1 —
Duplex Half-duplex —
Débit de données 2.5 Mbps (max, SP485E non-slew-limited) —
Supply Voltage (VCC) 4.75 V to 5.25 V —
Receiver Input Sensitivity ±200 mV [DATA_NEEDED: receiver input sensitivity]
Receiver Input Impedance 12 kΩ minimum, 15 kΩ typical —
Common-Mode Range −7 V to +12 V —
ESD Protection (HBM) ±15 kV —
ESD Protection (IEC 61000-4-2 Air Discharge) ±15 kV —
Plage de température de fonctionnement [DATA_NEEDED: operating temperature] [DATA_NEEDED: operating temperature range]
Boîtier 8-pin NSOIC or PDIP 8-pin SOIC
Type de montage Surface Mount (NSOIC) or Through-Hole (PDIP) Surface mount
Process Technology BiCMOS —
Failsafe Receiver Yes (open, shorted, idle bus) —
Tri-State Enable Pins Yes (DE, RE) —
Statut RoHS Compliant unknown
Product Type — RS-485/RS-422 transceiver
Transceiver Configuration — 1 driver and 1 receiver
Operating Mode — Half-duplex
Supply Voltage Range — 4.75 V to 5.25 V
Maximum Data Rate — 2.5 Mbps
Slew Rate Limiting — Not limited
Driver Short-Circuit Protection — Current limited and protected
Supported Standards — RS-485 and RS-422
Package Pin Count — 8 pins
Courant d'alimentation — [DATA_NEEDED: supply current]
Driver Output Current — [DATA_NEEDED: driver output current]
Common-Mode Voltage Range — [DATA_NEEDED: common-mode voltage range]
ESD Protection — [DATA_NEEDED: ESD protection rating]
REACH Status — unknown
AEC-Q100 Qualification — unknown

Fiches techniques et ressources

Parcourir tous les produits Créer un BOM Demander un devis