MAX485ESA+T vs SP485E तुलना
विस्तृत दोनों ओर की तुलना MAX485ESA+T द्वारा Analog Devices और SP485E द्वारा MaxLinear. मुख्य विशेषताओं, इलेक्ट्रिकल पैरामीटर, पैकेजिंग, चक्र स्थिति, मूल्यांकन और उपलब्धता को तुलना करके अपनी डिजाइन की आवश्यकताओं के लिए सबसे अच्छा घटक निर्धारित करें。
MaxLinear
SP485E - Enhanced Low Power Half-Duplex RS-485/RS-422 Transceiver | MaxLinear
SP485E ✓ सक्रियविशेषता तुलना
| पैरामीटर | MAX485ESA+T | SP485E |
|---|---|---|
| ब्रांड | Analog Devices | MaxLinear |
| श्रेणी | Interface ICs | Interface ICs |
| लाइफसाइकिल स्थिति | सक्रिय | सक्रिय |
| Product Type | RS-485/RS-422 transceiver | — |
| Transceiver Configuration | 1 driver and 1 receiver | — |
| Operating Mode | Half-duplex | — |
| Supply Voltage Range | 4.75 V to 5.25 V | — |
| Maximum Data Rate | 2.5 Mbps | — |
| Slew Rate Limiting | Not limited | — |
| Driver Short-Circuit Protection | Current limited and protected | — |
| Supported Standards | RS-485 and RS-422 | — |
| पैकेज | 8-pin SOIC | 8-pin NSOIC or PDIP |
| Package Pin Count | 8 pins | — |
| माउंटिंग प्रकार | Surface mount | Surface Mount (NSOIC) or Through-Hole (PDIP) |
| ऑपरेटिंग तापमान रेंज | [DATA_NEEDED: operating temperature range] | [DATA_NEEDED: operating temperature] |
| सप्लाई करंट | [DATA_NEEDED: supply current] | — |
| Driver Output Current | [DATA_NEEDED: driver output current] | — |
| Receiver Input Sensitivity | [DATA_NEEDED: receiver input sensitivity] | ±200 mV |
| Common-Mode Voltage Range | [DATA_NEEDED: common-mode voltage range] | — |
| ESD Protection | [DATA_NEEDED: ESD protection rating] | — |
| RoHS स्थिति | unknown | Compliant |
| REACH Status | unknown | — |
| AEC-Q100 Qualification | unknown | — |
| फ़ंक्शन | — | Transceiver |
| Protocol | — | RS-485, RS-422 |
| Number of Drivers/Receivers | — | 1/1 |
| Duplex | — | Half-duplex |
| डेटा दर | — | 2.5 Mbps (max, SP485E non-slew-limited) |
| Supply Voltage (VCC) | — | 4.75 V to 5.25 V |
| Receiver Input Impedance | — | 12 kΩ minimum, 15 kΩ typical |
| Common-Mode Range | — | −7 V to +12 V |
| ESD Protection (HBM) | — | ±15 kV |
| ESD Protection (IEC 61000-4-2 Air Discharge) | — | ±15 kV |
| Process Technology | — | BiCMOS |
| Failsafe Receiver | — | Yes (open, shorted, idle bus) |
| Tri-State Enable Pins | — | Yes (DE, RE) |