MAX3232CDWRG4
MAX3232CDWRG4 - Dual 250kbps RS-232 Transceiver | Texas Instruments
The Texas Instruments MAX3232CDWRG4 is a dual-channel RS-232 line driver and receiver operating from 3 V to 5.5 V at data rates up to 250 kbps, with ±15 kV ESD protection, in a 16-pin SOIC package. The device combines two RS-232 drivers, two receivers, and an on-chip charge-pump supply in one compact interface circuit. Its commercial temperature grade supports operation from 0°C to 70°C.
An RS-232 transceiver is an interface IC that converts low-voltage digital logic signals into RS-232 voltage levels and converts incoming RS-232 levels back into logic-compatible signals. Within the electronics hierarchy, the MAX3232 belongs to the interface IC family, where line drivers and receivers bridge computer or embedded-system logic with a differential, bipolar signaling interface. It is designed for point-to-point serial links where the full RS-232 voltage range, noise tolerance, and ESD resilience are more important than low-voltage logic-only communication.
The MAX3232 family supports 3 V and 5 V supply operation, allowing use with modern 3.3 V systems as well as conventional 5 V equipment. Its maximum signaling rate of 250 kbps supports data-transfer rates commonly required by serial console, instrumentation, and industrial-control interfaces. The integrated charge pump generates the positive and negative voltages required by RS-232 transmitters without a separate negative supply, while ±15 kV human-body-model ESD protection improves robustness at externally accessible connector pins.
The receiver section uses approximately 300 mV of hysteresis to distinguish valid logic states in the presence of noise. This threshold helps prevent repeated transitions near the signal threshold, which can otherwise cause corrupted characters or erratic framing. The two-channel arrangement provides one full-duplex path per channel, allowing simultaneous transmission and reception on each RS-232 link when the connected equipment and protocol support that direction of traffic.
Typical uses include industrial serial consoles, test and measurement equipment, point-of-sale terminals, data-acquisition systems, and embedded-control boards. The device is particularly appropriate where equipment uses DB9 or equivalent RS-232 connectors and needs a compact interface solution operating from a single 3 V or 5 V rail. Its ±15 kV ESD rating is especially relevant where the serial cable leaves an enclosure or connects to user-accessible equipment.
Designers should follow the manufacturer datasheet for the exact charge-pump capacitor values, driver and receiver pin assignments, and recommended layout. Keep the external capacitor connections short, provide a stable supply-decoupling path, and route the driver outputs toward the connector while separating them from sensitive receiver inputs. Do not treat ±15 kV ESD protection as a substitute for enclosure grounding, cable shielding, or external surge protection.
This product page combines the manufacturer's electrical specifications with an application-focused comparison of temperature grades, package compatibility, interface alternatives, and practical PCB considerations. It also distinguishes direct replacement options from broader RS-232 transceiver families, helping engineers confirm footprint, logic-level, speed, and protection requirements before approving a substitution.
Permintaan RFG
Kontak