EPC1PI8 vs EPC1PC8 Perbandingan
Perbandingan bersamaan detil EPC1PI8 dari Altera dan EPC1PC8 dari Altera. Bandingkan spesifikasi penting, parameter listrik, pengemasan, status cycle, harga, dan ketersediaan untuk menentukan komponen terbaik untuk kebutuhan desain Anda.
Perbandingan Spesifikasi
| Parameter Umum | EPC1PI8 | EPC1PC8 |
|---|---|---|
| Merek | Altera | Altera |
| Kategori | Memory ICs | Memory ICs |
| Status Lingkungan Hidup | Obsolete | Obsolete |
| Tipe Memori | OTP Configuration PROM (EPROM-based) | OTP Configuration PROM (Non-volatile) |
| Ukuran Memori | 1 Mbit | 1 Mbit (1,048,576 bits) |
| Programmable Type | OTP (One-Time Programmable) | — |
| Antarmuka | Serial (Altera FPGA configuration protocol) | — |
| Maximum Configuration Clock (DCLK) | 8 MHz | — |
| Supply Voltage (VCC) | 4.5 V to 5.5 V (5 V mode); 3.0 V to 3.6 V (3.3 V mode) | 5.0 V (typical) |
| Rentang Suhu Kerja | -40 C to +85 C | — |
| Paket | 8-PDIP (0.300 inch, 7.62 mm) | 8-pin PDIP (8-PDIP, 300 mil) |
| Tipe Mounting | Through-Hole (DIP) | Through-Hole (THT) |
| Supported FPGA Families | ACEX 1K, APEX 20K, APEX II, Arria GX, Cyclone, Cyclone II, FLEX 10K, FLEX 6000, Mercury, Stratix, Stratix GX, Stratix II, Stratix II GX | — |
| Configuration Mode | Serial (PS mode) - Data, DCLK, nCS, OE/nCONFIG | Serial (1-bit data, 1-bit clock) |
| Programming Method | External programmer + Altera BitBlaster / ByteBlaster | — |
| Jumlah Pin | 8 | — |
| Status RoHS | [DATA_NEEDED: RoHS status - not present in verified web data] | [DATA_NEEDED: RoHS compliance status] |
| Lead-Free | [DATA_NEEDED: lead-free status] | [DATA_NEEDED: lead-free / SnPb plating] |
| Configuration Interface | — | Altera proprietary serial (DATA, DCLK, OE, nCS) |
| Programmability | — | One-Time Programmable (OTP) |
| Target FPGAs | — | ACEX 1K, APEX 20K/20KE/20KC, FLEX 10K/10KE/10KA, FLEX 6000/A |
| Pin Pitch | — | 2.54 mm (0.100 in) |
| Suhu Kerja | — | 0 C to +70 C (commercial) [DATA_NEEDED: full min/max range] |
| Programming Hardware | — | Altera MasterBlaster / ByteBlaster (legacy programmer) |
| Level MSL | — | [DATA_NEEDED: moisture sensitivity level] |