INA157UA vs INA157U 比較
詳細な並列比較: INA157UA メーカー: Texas Instruments および INA157U メーカー: Texas Instruments。主要仕様、電気的特性、パッケージ、ライフサイクルステータス、価格、在庫状況を比較して、設計要件に最適な部品を判断してください。
仕様比較
| パラメータ | INA157UA | INA157U |
|---|---|---|
| ブランド | Texas Instruments | Texas Instruments |
| カテゴリ | Amplifier ICs | Amplifier ICs |
| ライフサイクル状態 | 有効 | 有効 |
| Device Type | High-speed, precision difference amplifier | — |
| Number of Amplifier Channels | 1 channel | — |
| Bandwidth | 4 MHz | 3 MHz |
| Offset Voltage | ±500 µV maximum | — |
| Offset Voltage Drift | ±2 µV/°C maximum | — |
| Gain Error | ±0.05% maximum | — |
| Differential Gain | 1 V/V | — |
| Internal Resistor Network | Precision, laser-trimmed | Precision, ratio-matched, laser-trimmed |
| パッケージ | 8-pin SOIC (D) | 8-pin SOIC |
| 実装タイプ | Surface mount | Surface mount |
| 動作温度範囲 | -55 °C to +125 °C | -40°C to +85°C |
| 電源電圧 | [DATA_NEEDED: supply voltage range] | — |
| Maximum Output Voltage | [DATA_NEEDED: maximum output voltage] | — |
| Input Common-Mode Voltage Range | [DATA_NEEDED: input common-mode voltage range] | — |
| 静止電流 | [DATA_NEEDED: quiescent current] | — |
| 電源電流 | [DATA_NEEDED: supply current] | — |
| Slew Rate | [DATA_NEEDED: slew rate] | [DATA_NEEDED: slew rate] |
| Common-Mode Rejection Ratio | [DATA_NEEDED: common-mode rejection ratio] | — |
| RoHS ステータス | unknown | unknown |
| REACH Status | unknown | — |
| AEC-Q100 Qualification | not_applicable | — |
| Product Type | — | High-speed, precision difference amplifier |
| Maximum Offset Voltage | — | ±500 µV |
| Maximum Offset Drift | — | ±2 µV/°C |
| Maximum Gain Error | — | ±0.05% |
| Circuit Count | — | 1 circuit |
| Internal Resistor Absolute Tolerance | — | ±20% |
| Input Bias Current | — | [DATA_NEEDED: input bias current] |
| Input Offset Current | — | [DATA_NEEDED: input offset current] |
| Supply Voltage Range | — | [DATA_NEEDED: supply voltage range] |
| Common-Mode Voltage Range | — | [DATA_NEEDED: common-mode input voltage range] |
| Output Voltage Swing | — | [DATA_NEEDED: output voltage swing] |
| Input Noise | — | [DATA_NEEDED: input voltage noise] |