LM2901PWR vs LM2904PWR 比較
詳細な並列比較: LM2901PWR メーカー: Texas Instruments および LM2904PWR メーカー: Texas Instruments。主要仕様、電気的特性、パッケージ、ライフサイクルステータス、価格、在庫状況を比較して、設計要件に最適な部品を判断してください。
Texas Instruments
LM2901PWR - Quad 30V Open-Collector Comparator | Texas Instruments
LM2901PWR ✓ 生産中Texas Instruments
LM2904PWR - Dual 700 kHz Op Amp, 26 V | Texas Instruments (Tape & Reel)
LM2904PWR ✓ 生産中仕様比較
| パラメータ | LM2901PWR | LM2904PWR |
|---|---|---|
| ブランド | Texas Instruments | Texas Instruments |
| カテゴリ | Amplifier ICs | Amplifier ICs |
| ライフサイクル状態 | 有効 | 有効 |
| Comparator Type | General-purpose differential comparator | — |
| Number of Channels | 4 channels | — |
| 電源電圧 | 2 V to 36 V | — |
| Dual Supply Voltage | ±1 V to ±18 V | — |
| Maximum Rated Supply | 38 V | — |
| 出力タイプ | Open-collector | — |
| Logic Compatibility | TTL, MOS, and CMOS | — |
| Low Input Offset Voltage | 0.37 mV | — |
| Low Input Bias Current | 3.5 nA | — |
| 電源電流 | 200 µA per comparator | — |
| Response Time | 1 µs | — |
| Common-Mode Input Range | Includes ground | Includes ground |
| Differential Input Voltage Range | ±38 V | — |
| ESD Rating | 2 kV HBM | — |
| パッケージ | 14-pin TSSOP | 8-TSSOP, 4.40 mm width |
| 実装タイプ | Surface mount | Surface mount |
| Output Saturation Voltage | [DATA_NEEDED: output saturation voltage] | — |
| 動作温度範囲 | [DATA_NEEDED: operating temperature range] | [DATA_NEEDED: operating temperature range] |
| RoHS ステータス | [DATA_NEEDED: RoHS compliance status] | [DATA_NEEDED: RoHS status] |
| REACH Status | [DATA_NEEDED: REACH compliance status] | [DATA_NEEDED: REACH status] |
| Number of Amplifiers | — | 2 circuits |
| Product Type | — | Dual general-purpose operational amplifier |
| Maximum Supply Voltage | — | 26 V |
| Gain-Bandwidth Product | — | 700 kHz |
| Typical Supply Current | — | 0.7 mA |
| Supply-Current Independence | — | Independent of supply voltage |
| Supported Supply Configurations | — | Single supply or split supply |
| Architecture | — | Voltage feedback, internally frequency compensated |
| Package Length | — | 4.40 mm |
| Input Offset Voltage | — | [DATA_NEEDED: input offset voltage] |
| Input Bias Current | — | [DATA_NEEDED: input bias current] |
| Slew Rate | — | [DATA_NEEDED: slew rate] |
| AEC-Q100 Qualification | — | [DATA_NEEDED: AEC-Q100 qualification status] |