MAX3485ESA+T vs SN65HVD73DGSR 比較
詳細な並列比較: MAX3485ESA+T メーカー: Analog Devices および SN65HVD73DGSR メーカー: Texas Instruments。主要仕様、電気的特性、パッケージ、ライフサイクルステータス、価格、在庫状況を比較して、設計要件に最適な部品を判断してください。
Texas Instruments
SN65HVD73DGSR - 3.3V Full-Duplex RS-485, 20Mbps, 12kV ESD | TI
SN65HVD73DGSR ✓ 生産中仕様比較
| パラメータ | MAX3485ESA+T | SN65HVD73DGSR |
|---|---|---|
| ブランド | Analog Devices | Texas Instruments |
| カテゴリ | Interface ICs | Interface ICs |
| ライフサイクル状態 | 有効 | 有効 |
| Product Type | RS-485/RS-422 transceiver | RS-485 / RS-422 Full-Duplex Transceiver |
| 電源電圧 | 3.3 V | — |
| Maximum Data Rate | 10 Mbps | — |
| Driver Count | 1 | — |
| Receiver Count | 1 | — |
| Duplex Mode | Half-duplex | — |
| Supported Standards | RS-422 and RS-485 | — |
| パッケージ | 8-SOIC | VSSOP-10 (DGS), 3.00 mm × 3.00 mm, PowerPAD |
| Package Dimensions | 3.90 mm width | — |
| 実装タイプ | Surface mount | Surface Mount |
| Ordering Package | Tape and reel | — |
| 動作温度範囲 | [DATA_NEEDED: operating temperature range] | -40 °C to +125 °C |
| 電源電流 | [DATA_NEEDED: supply current] | — |
| Driver Propagation Delay | [DATA_NEEDED: driver propagation delay] | — |
| Receiver Propagation Delay | [DATA_NEEDED: receiver propagation delay] | — |
| ESD Protection | [DATA_NEEDED: ESD protection rating] | — |
| Common-Mode Voltage Range | [DATA_NEEDED: receiver common-mode voltage range] | [DATA_NEEDED: -7 V to +12 V typical] |
| RoHS Compliance | [DATA_NEEDED: RoHS compliance status] | — |
| REACH Compliance | [DATA_NEEDED: REACH compliance status] | — |
| Part Number | — | SN65HVD73DGSR |
| Manufacturer | — | Texas Instruments |
| Supply Voltage (VCC) | — | 3.0 V to 3.6 V |
| Data Rate (max) | — | 20 Mbps |
| Number of Drivers / Receivers | — | 1 / 1 |
| Duplex | — | Full |
| Receiver Hysteresis | — | [DATA_NEEDED: typical receiver hysteresis in mV] |
| ESD Protection - HBM (bus pins) | — | ±30 kV |
| ESD Protection - IEC 61000-4-2 Contact (bus pins) | — | ±12 kV |
| Unit Load | — | 1/8 (up to 256 nodes) |
| RoHS ステータス | — | Compliant |
| MSLレベル | — | [DATA_NEEDED: MSL rating per JEDEC J-STD-020] |
| Enable Pins | — | DE (driver enable, active-high); RE (receiver enable, active-low) |