TL072CP vs TL072CDR 比較
詳細な並列比較: TL072CP メーカー: Texas Instruments および TL072CDR メーカー: Texas Instruments。主要仕様、電気的特性、パッケージ、ライフサイクルステータス、価格、在庫状況を比較して、設計要件に最適な部品を判断してください。
Texas Instruments
TL072CP - Dual JFET-Input Low-Noise Op Amp, 8-PDIP | Texas Instruments
TL072CP ✓ 生産中
仕様比較
| パラメータ | TL072CP | TL072CDR |
|---|---|---|
| ブランド | Texas Instruments | Texas Instruments |
| カテゴリ | Amplifier ICs | Amplifier ICs |
| ライフサイクル状態 | 有効 | 有効 |
| 在庫状況 | In Stock | In Stock |
| 単価（USD） | $0.31 | $0.09 |
| Manufacturer | Texas Instruments | — |
| Part Status | Active | — |
| Amplifier Type | JFET-Input Operational Amplifier | Dual operational amplifier |
| Number of Circuits | 2 (Dual) | — |
| Slew Rate | 13 V/µs (typical) | 13 V/µs |
| Gain Bandwidth Product | 3 MHz (typical) | — |
| Input Bias Current | 30 pA (typical) | Low; exact value not supplied in verified data |
| Input Offset Voltage | 3 mV (typical, C grade) | [DATA_NEEDED: input offset voltage] |
| Input Noise Voltage Density | 18 nV/√Hz (typical at 1 kHz) | — |
| Total Harmonic Distortion | 0.003% (typical) | — |
| Supply Voltage Range (Dual) | ±3.5 V to ±18 V | — |
| Supply Voltage Range (Single) | 7 V to 36 V | — |
| 動作温度範囲 | 0°C to +70°C (C grade) | [DATA_NEEDED: operating temperature range] |
| パッケージ / ケース | 8-PDIP (Plastic DIP, through-hole) | — |
| 実装タイプ | Through Hole | Surface mount |
| ピン数 | 8 | — |
| Output Short-Circuit Protection | Yes | Yes |
| Internal Frequency Compensation | Yes | — |
| Latch-up Free Operation | Yes | — |
| RoHS ステータス | Compliant | — |
| Input Stage | — | JFET-input |
| Number of Amplifiers | — | 2 |
| Gain-Bandwidth Product | — | 3 MHz |
| Listed Supply Voltage Range | — | 7 V to 36 V |
| パッケージ | — | 8-pin SOIC |
| Frequency Compensation | — | Internal |
| Input Impedance | — | High; exact value not supplied in verified data |
| Low Total Harmonic Distortion | — | Yes; exact value not supplied in verified data |
| 出力ノイズ | — | [DATA_NEEDED: output noise] |
| Common-Mode Rejection | — | [DATA_NEEDED: common-mode rejection] |
| 電源電流 | — | [DATA_NEEDED: supply current] |