LM2902VDTBG
LM2902VDTBG - Quad 3-26V Op Amp | onsemi | Industrial
The onsemi LM2902VDTBG is a standard general-purpose quad operational amplifier packaged in a 14-pin TSSOP. It combines four amplifier channels with a 3 V to 26 V supply-voltage range, low-power operation, and extended-temperature capability, making it suitable for industrial control, instrumentation, sensor-conditioning, and general analog signal-processing systems. The device is offered in the PDSO14 package and is identified by DigiKey as a 4-circuit, 14-TSSOP amplifier.
An operational amplifier is an active analog component that uses high-gain differential feedback to amplify the voltage difference between its two inputs. The quad LM2902 configuration integrates four amplifiers into one package, reducing board area when a system requires several independent signal-conditioning channels. In the signal-chain hierarchy, the LM2902 belongs to the operational-amplifier family, which is part of analog signal-chain ICs and ultimately semiconductor devices used for measurement, control, conversion, and buffering.
The LM2902 series provides four general-purpose amplifier sections in one device. According to onsemi’s LM2902 documentation, the series supports operation from low-voltage single-supply systems to higher-voltage supplies. The Mouser listing identifies the LM2902VDTBG as a 3 V to 26 V, low-power, extended-temperature quad amplifier. A GlobalSpec result identifies the device as a bipolar quad operational amplifier with a maximum input offset voltage of 7000 uV, while the DigiKey listing characterizes it as a standard general-purpose amplifier.
Each amplifier section includes non-inverting and inverting inputs and an output, allowing the device to support voltage followers, noninverting amplifiers, inverting amplifiers, summing circuits, comparators, and differential signal conditioning. Because four amplifiers share one package, engineers can allocate them across related channels such as a sensor input, its reference, an output driver, and an auxiliary monitor. Exact input-offset, input-bias-current, gain-bandwidth, slew-rate, output-current, and noise figures should be selected from the operating conditions in the onsemi datasheet before committing a high-accuracy design.
Typical uses include industrial transducers, temperature and pressure sensor interfaces, low-level signal amplification, control-system signal conditioning, audio preamplification, and general-purpose buffering. Its quad organization is particularly useful when a board needs several similar analog channels without allocating separate packages for each amplifier. The 14-pin TSSOP footprint also supports compact surface-mount layouts, although pin pitch and exposed thermal behavior remain important layout considerations.
When designing around the LM2902VDTBG, begin with the four complete amplifier sections and confirm the required input common-mode range, output swing, supply current, noise, and stability behavior at the intended supply voltage. Decoupling capacitors should be placed close to the supply pins, and sensitive input traces should be routed away from switching nodes. Because the exact electrical limits are governed by the manufacturer datasheet, verify the operating temperature, package dimensions, pin orientation, and gain-bandwidth requirements against the final circuit and PCB constraints.
This product record organizes the manufacturer and distributor information for LM2902VDTBG with practical guidance for signal-chain design, source selection, and footprint verification. It also identifies the limits of the available replacement information so that engineers can distinguish confirmed package compatibility from merely similar amplifier families.
RFC
Hubungi kami