EPC2TC32UCAF48 vs EPC2TC32UCF48 Pengandingan
Pengandingan Sisi Kiri Sisi Kanan Terperinci EPC2TC32UCAF48 disebabkan oleh Altera dan EPC2TC32UCF48 disebabkan oleh Intel. Bandingkan spesifikasi utama, parameter elektrik, pakej, status kehidupan, harga, dan keupayaan untuk menentukan komponen terbaik untuk keperluan disenjaya anda.
Pengandingan Spesifikasi
| Parametr | EPC2TC32UCAF48 | EPC2TC32UCF48 |
|---|---|---|
| Merek | Altera | Intel |
| Kategori | FPGA & CPLD | Memory ICs |
| Status Lingkungan Hidup | Obsolete | NRND |
| Saiz Ingatan | 1.6 Mb | — |
| Device Family | EPC2 (Enhanced Configuration Device) | — |
| Programmability | In-system programmable (ISP) via JTAG | — |
| Antaramuka | 4-wire serial (nCS, DCLK, DATA, nINIT_CONF) + JTAG | — |
| Supply Voltage (VCC) | 3.3 V nominal | 3.0 V to 3.6 V (3.3 V typical) |
| FPGA Compatibility | Altera SRAM-based LUT FPGAs (Cyclone, Stratix, APEX, ACEX, FLEX, MAX 9000) | — |
| Cascading | Supported for bitstreams larger than 1.6 Mb | — |
| Kemasan | 32-pin TQFP (CAF48 designation per Altera ordering code) | 48-pin TQFP (7x7 mm) |
| Suhu Operasi | [DATA_NEEDED: commercial 0-70C vs industrial -40-85C variant] | 0C to +70C (commercial) |
| Data Retention | 10 years typical (EEPROM-based) | — |
| Programming Cycles | 100 cycles minimum (EEPROM endurance) | — |
| Process Technology | CMOS EEPROM | — |
| Jenis Pemasangan | Surface Mount | Surface Mount |
| Aras MSL | [DATA_NEEDED: MSL classification] | [DATA_NEEDED: MSL rating] |
| Status RoHS | [DATA_NEEDED: per ordering code; older CAF48 lots were non-RoHS] | [DATA_NEEDED: confirm RoHS compliance] |
| Jenis Ingatan | — | Non-volatile configuration PROM (CMOS Flash-based) |
| Memory Density | — | 1.6 Mbit (1.6 Mb / 32 Mbit raw) |
| Memory Configuration | — | Serial configuration bitstream storage |
| Supply Voltage (VCCIO) | — | 1.8 V / 2.5 V / 3.3 V (bank-level) |
| Output Drive Current (VCCIO) | — | [DATA_NEEDED: IOH/IOL at 3.3 V VCCIO] |
| Programming Interface | — | IEEE Std. 1149.1 JTAG (in-system programmable) |
| Configuration Interface | — | Altera serial PROM interface (DCLK, DATA, nCONFIG, nSTATUS, CONF_DONE) |
| Supported Configuration Modes | — | FPP, AS, PS, JTAG (mode dependent on target FPGA MSEL pins) |
| Daisy Chain Support | — | Yes (multi-device cascade for >16 Mbit FPGAs) |
| Maximum Cascaded Capacity | — | Up to 16 Mbit total across chain |
| Lead Free | — | [DATA_NEEDED: confirm lead-free] |