KSZ8041FTL-S vs KSZ8041TL Pengandingan
Pengandingan Sisi Kiri Sisi Kanan Terperinci KSZ8041FTL-S disebabkan oleh Microchip Technology dan KSZ8041TL disebabkan oleh Microchip Technology. Bandingkan spesifikasi utama, parameter elektrik, pakej, status kehidupan, harga, dan keupayaan untuk menentukan komponen terbaik untuk keperluan disenjaya anda.
Pengandingan Spesifikasi
| Parametr | KSZ8041FTL-S | KSZ8041TL |
|---|---|---|
| Merek | Microchip Technology | Microchip Technology |
| Kategori | Interface ICs | Interface ICs |
| Status Lingkungan Hidup | Aktif | Aktif |
| Product Type | 10/100 Ethernet physical-layer transceiver | 10BASE-T/100BASE-TX Ethernet physical-layer transceiver |
| Ethernet Standards | 10Base-T and 100Base-TX | — |
| Host Interface | MII, RMII, and SMII | — |
| Number of Transmitters | 1 channel | — |
| Number of Receivers | 1 channel | — |
| Supply Voltage Range | 3.135 V to 3.465 V | — |
| Supply Type | Single supply | — |
| Auto MDI/MDIX Support | HP Auto MDI/MDIX | — |
| Kemasan | 48-TQFP, 7 x 7 mm | 48-TQFP (7 x 7 mm) |
| Kiraan Pin | 48 pins | — |
| Jenis Pemasangan | Surface mount | Surface mount |
| Kadar Data | 10 Mb/s and 100 Mb/s | — |
| Mixed-Signal Architecture | Extended signaling distance and reduced power consumption | — |
| Configuration Strapping | Speed, duplex, auto-negotiation, power-down, and PHY address | — |
| Suhu Operasi | [DATA_NEEDED: operating temperature range] | [DATA_NEEDED: operating temperature range] |
| Status RoHS | [DATA_NEEDED: RoHS status] | [DATA_NEEDED: RoHS status] |
| REACH Status | [DATA_NEEDED: REACH status] | [DATA_NEEDED: REACH status] |
| AEC-Q100 Qualification | [DATA_NEEDED: AEC-Q100 qualification] | — |
| Supported Data Rates | — | 10 Mb/s and 100 Mb/s |
| Host Interfaces | — | MII, RMII, and SMII |
| Supply Architecture | — | Single-supply |
| Cable Standard | — | 10BASE-T and 100BASE-TX |
| Mixed-Signal Design | — | Yes; intended to extend signaling distance while reducing power consumption |
| Auto MDI/MDIX | — | HP Auto MDI/MDIX |
| Interrupt Signal | — | INTRP on pin 32; optional PHY-register status-update signal |
| Number of Drivers/Receivers | — | 1 driver and 1 receiver |
| Device Type | — | Ethernet interface IC / physical-layer transceiver |
| Tegangan Pemberi Arus | — | [DATA_NEEDED: supply voltage range] |
| Interface Clock | — | [DATA_NEEDED: clock frequency] |
| Ethernet Magnetics | — | [DATA_NEEDED: supported magnetics and isolation configuration] |
| Automotive Qualification | — | [DATA_NEEDED: AEC-Q100 qualification] |