MAX3483ESA+ vs SN65HVD37D Pengandingan
Pengandingan Sisi Kiri Sisi Kanan Terperinci MAX3483ESA+ disebabkan oleh Maxim Integrated dan SN65HVD37D disebabkan oleh Texas Instruments. Bandingkan spesifikasi utama, parameter elektrik, pakej, status kehidupan, harga, dan keupayaan untuk menentukan komponen terbaik untuk keperluan disenjaya anda.
Texas Instruments
SN65HVD37D - 3.3V Full-Duplex RS-485 Transceiver | TI (Tape & Reel)
SN65HVD37D ✓ AktifPengandingan Spesifikasi
| Parametr | MAX3483ESA+ | SN65HVD37D |
|---|---|---|
| Merek | Maxim Integrated | Texas Instruments |
| Kategori | Interface ICs | Interface ICs |
| Status Lingkungan Hidup | Aktif | Aktif |
| Product Type | RS-485/RS-422 transceiver | — |
| Tegangan Pemberi Arus | 3.3 V | — |
| Verified Supply Range | 3 V to 3.6 V | — |
| Maximum Data Rate | 10 Mbps | — |
| Driver and Receiver Count | 1 driver and 1 receiver | — |
| Duplex Mode | Half-duplex | — |
| Interface Standards | RS-485 and RS-422 | — |
| Driver Architecture | Slew-rate limited | — |
| EMI Control | Slew-rate limitation reduces EMI and reflections | — |
| Low-Speed Error-Free Transmission | Up to 250 kbps | — |
| Power Architecture | 3.3V-powered, low-power transceiver | — |
| Kemasan | 8-SOIC | 14-SOIC (D), 0.154" / 3.90 mm width |
| Jenis Pemasangan | Surface mount | Surface Mount |
| Operating Voltage | 3 V to 3.6 V | — |
| ESD Protection | [DATA_NEEDED: ESD protection rating for MAX3483ESA+] | — |
| Gambaran Suhu Operasi | [DATA_NEEDED: operating temperature range] | — |
| Arus Pemberi Arus | [DATA_NEEDED: supply current] | — |
| Receiver Output Type | [DATA_NEEDED: receiver output type] | — |
| Termination Requirement | [DATA_NEEDED: termination and biasing details] | — |
| Status RoHS | [DATA_NEEDED: RoHS status] | — |
| REACH Status | [DATA_NEEDED: REACH status] | — |
| AEC-Q100 Qualification | [DATA_NEEDED: AEC-Q100 qualification] | — |
| Lead-Free Status | [DATA_NEEDED: lead-free status] | — |
| Halogen-Free Status | [DATA_NEEDED: halogen-free status] | — |
| Device Type | — | Transceiver (1 driver / 1 receiver) |
| Protocol | — | RS-422, RS-485 |
| Number of Drivers/Receivers | — | 1 / 1 |
| Duplex | — | Full |
| Supply Voltage (VCC) | — | 3 V to 3.6 V (nominal 3.3 V) |
| Signaling Rate | — | Up to 25 Mbps |
| Receiver Unit Load | — | 1/8 unit load (up to 256 nodes) |
| Bus-Pin ESD Protection (HBM) | — | >15 kV HBM |
| Receiver Hysteresis | — | 60 mV (typical) |
| Quiescent Current (active) | — | 1 mA (typical) |
| Standby / Shutdown Current | — | <1 uA (typical) |
| Suhu Operasi | — | -40 C to +85 C |
| RoHS / Lead-Free | — | RoHS compliant, lead-free (per TI product page) |
| Fail-Safe Receiver | — | Yes (idle/open/short safe) |
| Driver / Receiver Enable | — | Independent DE and RE pins |