SN65HVD3085EDR vs SN65LBC176DR Сравнение
Подробное сравнение бок о бок SN65HVD3085EDR от Texas Instruments и SN65LBC176DR от Texas Instruments. Сравните ключевые характеристики, электрические параметры, упаковку, статус жизненного цикла, цены и наличие, чтобы выбрать лучший компонент для ваших требований.
Texas Instruments
SN65LBC176DR - 10Mbps RS-485 Transceiver 5V | Texas Instruments
SN65LBC176DR ✓ АктивенСравнение характеристик
| Параметр | SN65HVD3085EDR | SN65LBC176DR |
|---|---|---|
| Бренд | Texas Instruments | Texas Instruments |
| Категория | Interface ICs | Interface ICs |
| Статус жизненного цикла | Активен | Активен |
| Наличие | In Stock | In Stock |
| Цена за единицу (USD) | $0,32 | $1,27 |
| Protocol | RS-485, RS-422 (TIA/EIA-485A compliant) | — |
| Duplex Mode | Half-duplex | — |
| Number of Drivers / Receivers | 1 / 1 | — |
| Напряжение питания | 4.5 V to 5.5 V | 5 V (nominal) |
| Signaling Rate | Up to 20 Mbps | 10 Mbps (max) |
| Рабочая температура | -40C to +85C | -40C to +85C |
| Корпус | SOIC (D), 8 pins | 8-SOIC (D), 3.90 mm width |
| Тип монтажа | Surface Mount | Surface Mount |
| Receiver Hysteresis | Specified in manufacturer datasheet | — |
| Bus Pin ESD / Fault Tolerance | Per TIA/EIA-485A requirements | — |
| Driver Output Transition Time | Controlled (slew-limited for long cables) | — |
| Isolation | None (non-isolated) | — |
| Функция | Low-power half-duplex RS-485 transceiver | Half-duplex RS-485/RS-422 transceiver |
| Standard Packaging | Tape & Reel (R suffix) | — |
| Статус RoHS | Compliant (per Abacus Technologies listing) | Compliant |
| REACH Status | Compliant (per Abacus Technologies listing) | — |
| Duplex | — | Half |
| Transmitters / Receivers | — | 1 / 1 |
| Protocol Compliance | — | ANSI TIA/EIA-485 (RS-485), ISO 8482:1987 (E) |
| Fault Protection | — | -10 V to 15 V common-mode bus range |
| Driver Enable | — | DE, active-high |
| Receiver Enable | — | RE, active-low |
| Technology | — | LinBiCMOS, low skew |
| Количество выводов | — | 8 |
| Bus Loading | — | Up to 32 unit loads (multipoint) |