A54SX16A-TQG100I - 24K Gate Antifuse FPGA, 81 I/O | Microchip
Артикул: A54SX16A-TQG100I ✓ Активен| Кол-во | Цена за ед. | Итого |
|---|---|---|
| 1 | $48.5 | $48,50 |
| 10 | $44.2 | $442,00 |
| 100 | $39.8 | $3.980,00 |
| 500 | $36.1 | $18.050,00 |
| 1.000 | $32.9 | $32.900,00 |
A54SX16A-TQG100I Обзор
An antifuse FPGA is a type of field-programmable gate array whose interconnect is permanently programmed at power-up programming time via antifuse links, unlike SRAM-based FPGAs that reload configuration from an external flash device at every boot. Because the configuration is hard-wired, antifuse FPGAs sit within the programmable logic hierarchy (FPGA -> programmable logic device -> digital IC) as a one-time-programmable, non-volatile technology favored where bitstream security, instant-on operation, and radiation robustness matter.
Key features of the A54SX16A include the sea-of-modules architecture that simplifies design transfer from the older SX family, dedicated flip-flops with fast setup times, and low static power consumption typical of antifuse technology. With 24K system gates (expandable to 108,000 available system gates across the family), the device targets glue logic integration, bus bridging, state machines, and control-path functions consolidated into a single low-cost chip.
The SX-A architecture uses a sea-of-modules routing fabric with a fine-grained logic cell structure, enabling high logic utilization and predictable timing. Programming is performed once using Microchip (Actel) programming hardware; the programmed antifuse network is non-volatile and highly resistant to readback, providing a built-in security advantage over SRAM FPGAs that store bitstreams externally.
Typical applications include industrial control and automation boards, aerospace and defense subsystems requiring secure boot logic, communications interface bridging, and legacy design continuity for systems originally qualified around Actel SX/SX-A silicon.
When designing with the A54SX16A, remember that antifuse FPGAs are one-time-programmable: exhaustively verify the design in simulation and, where possible, use the same-family SX-A development flow before committing silicon. Package speed-grade and temperature variants are not interchangeable in programming files without re-timing verification.
This page synthesizes distributor pricing tiers, drop-in same-package alternatives from the SX-A family, and practical antifuse design notes not consolidated in the manufacturer datasheet.
Аналоги без доработки для A54SX16A-TQG100I — тот же корпус, pin-to-pin совместимость. Компоненты в других корпусах, требующие переработки PCB, исключены.
Варианты в этой серии
Модели той же серии, совместимые без доработки с A54SX16A-TQG100I (тот же форм-фактор и посадочное место) — отличается по Package, System Gates, Operating Temperature, RoHS Status, Family.
Инструмент быстрого сравнения — выберите альтернативные компоненты для сравнения бок о бок:
A54SX16A-1TQG100I
✅ Прямая замена✓ В наличии
$17.1 / шт.
Открыть даташит →A54SX16A-2TQG100I
✅ Прямая замена✓ В наличии
$21.85 / шт.
Открыть даташит →A54SX16A-2TQG100
✅ Прямая замена✓ В наличии
$134 / шт.
Открыть даташит →A54SX16A-TQG100A
✅ Прямая замена✓ В наличии
Уточнить цену
Открыть даташит →A54SX16A-TQG100
✅ Прямая замена✓ В наличии
$20.8 / шт.
Открыть даташит →A54SX32A-TQG100A
✅ Прямая замена✓ В наличии
$235 / шт.
Открыть даташит →A54SX32A-1TQG100I
✅ Прямая замена✓ В наличии
$38.5 / шт.
Открыть даташит →A54SX32A-2TQG100I
✅ Прямая замена✓ В наличии
$22.8 / шт.
Открыть даташит →A54SX16A-TQG100I Максимальные параметры и электрические характеристики
| Family | SX-A (antifuse FPGA) |
| System Gates | 24000 |
| Available System Gates (family max) | up to 108000 |
| User I/O | 81 |
| Dedicated Flip-Flops (family max) | up to 2012 |
| Process Technology | 0.25 um CMOS |
| Programmability | One-time programmable (antifuse), non-volatile |
| Корпус | 100-TQFP (TQG100) |
| Тип монтажа | Surface Mount |
| Рабочая температура | -40C to +85C (industrial, I suffix) |
| Статус RoHS | RoHS Compliant |
| Lead Free Status | Lead Free |
| Architecture | Sea-of-modules |
| Configuration Storage | No external configuration device required |
| Категория | FPGA - Field Programmable Gate Array |
Руководство по цоколевке A54SX16A-TQG100I в корпусе 100-tqfp (tqg100)
Цоколевка для A54SX16A-TQG100I (корпус 100-tqfp (tqg100)). Эта цифровая ИС включает выводы GPIO, интерфейсы связи (UART, SPI, I2C) и выводы питания. Обратитесь к техническому описанию производителя для альтернативных функций выводов и вариантов конфигурации. Необходимо для проектирования встраиваемых систем и трассировки печатных плат.
Нет подробных данных о распиновке для A54SX16A-TQG100I.
Обратитесь к даташиту для полной конфигурации выводов.
Типичное применение
A54SX16A-TQG100I подходит для 6 применениеs: Industrial Control and Automation, Aerospace and Defense Control Logic, Communications Interface Bridging, Secure Boot and Anti-Tamper Systems, Legacy Design Continuity and Obsolescence Mitigation, Portable and Low-Power Instrumentation.
Industrial Control and Automation
The A54SX16A-TQG100I integrates glue logic, bus interfaces, and state machines into one 24K-gate antifuse device, reducing BOM count and board area in PLC I/O cards, motor control boards, and sensor hubs. Its 81 user I/O handle parallel bus and discrete signal interfacing, while the industrial -40C to +85C rating matches factory-floor environments. Because the antifuse configuration is non-volatile, the board powers into a known-good logic state instantly with no configuration controller. Designers place it between a microprocessor and field-side circuitry, trading SRAM-FPGA reconfigurability for the deterministic, tamper-resistant behavior required in unattended automation equipment.
Рекомендуется
Aerospace and Defense Control Logic
Antifuse SX-A FPGAs are a long-standing choice in aerospace and defense subsystems because the programmed interconnect cannot be read back, eliminating bitstream-interception risk, and there is no configuration flash to fail under vibration or radiation stress. The A54SX16A-TQG100I provides 24,000 system gates and 2,012 dedicated flip-flops (family max) for telemetry formatting, command decoding, and sequencer logic. The industrial TQG100I grade suits development and less-critical programs, while military-screened M-suffix SX-A variants cover qualified builds. The instant-on, single-chip nature also simplifies power-up sequencing in launch vehicles and satellites where every boot cycle must be deterministic.
Рекомендуется
Communications Interface Bridging
With 81 user I/O and a fine-grained sea-of-modules fabric, the A54SX16A-TQG100I implements protocol bridges, serial-to-parallel converters, address decoders, and backplane glue logic in telecom and datacom line cards. The 0.25 um CMOS process and antifuse interconnect deliver low static power, valuable in rack equipment with high channel density. Its non-volatile configuration means a line card is active immediately on slot insertion, simplifying hot-swap behavior without a configuration manager. Timing in the SX-A family is predictable thanks to dedicated routing, easing integration of fixed-throughput interface paths where SRAM FPGA reconfiguration or boot delay is unacceptable.
Рекомендуется
Secure Boot and Anti-Tamper Systems
The one-time-programmable antifuse architecture of the A54SX16A-TQG100I makes it inherently suitable for secure-boot controllers, key-management glue logic, and anti-tamper front ends. Unlike SRAM FPGAs, there is no external bitstream to intercept, clone, or corrupt, and readback of the programmed design is not supported. Designs typically use the 24K system gates for authentication state machines, fuse-check sequencing, and lockout logic ahead of the main processor. For defense programs the device complements military-graded SX-A family members; the industrial TQG100I supports prototyping and non-qualified builds with identical footprint migration.
Рекомендуется
Legacy Design Continuity and Obsolescence Mitigation
Many long-lifecycle industrial, medical, and defense platforms were designed around Actel SX and SX-A devices. The A54SX16A-TQG100I, still active with Microchip factory stock (1,010 units at MicrochipDirect as of early 2026) and broad distributor availability, serves as the continuity part for these programs. Same-family, same-footprint variants such as the TQG100A, 1TQG100I, and 2TQG100I provide second-source purchasing options within one die family, and the A54SX32A TQG100 class allows density migration without PCB rework. Procurement teams use this page's cross-reference table to de-risk single-source BOM lines for decade-long product support commitments.
Рекомендуется
Portable and Low-Power Instrumentation
Battery-powered and handheld instruments benefit from the SX-A family's low static power and zero configuration energy: the antifuse FPGA consumes no boot current and needs no configuration flash, reducing both peak and average power. The A54SX16A-TQG100I implements sensor-interface sequencers, display drivers, and control glue in 24,000 gates with up to 81 I/O in a compact 100-pin TQFP (approximate 14x14 mm body class). The instant-on property lets the instrument become functional the moment power is applied, important for test probes and field meters. Designers pair it with a low-power MCU, reserving the FPGA fabric for parallel, timing-critical tasks.
Рекомендуется
Сводка рекомендуемых товаров
Справочные инженерные данные для A54SX16A-TQG100I — сравнение, рекомендации по проектированию и информация о соответствии.
Руководство по выбору
Сравнение с аналогами
| Параметр | Этот товар | A54SX16A-1TQG100I | A54SX16A-TQG100A | A54SX32A-1TQG100I |
|---|---|---|---|---|
| Package | 100-TQFP (TQG100) | 100-TQFP (TQG100) - same | 100-TQFP (TQG100) - same | 100-TQFP (TQG100) - same |
| Brand | Microchip Technology | Microchip Technology | Microchip Technology | Microchip Technology |
| System Gates | 24000 | 24000 | 24000 | 36000 (SX32A die) |
| Temperature Grade | Industrial (-40C to +85C, I suffix) | Industrial (I) | Automotive (A) | Industrial (I) |
| Speed Grade | Standard | Speed grade 1 | Standard | Speed grade 1 |
| Technology | Antifuse OTP, 0.25 um CMOS | Antifuse OTP, 0.25 um CMOS | Antifuse OTP, 0.25 um CMOS | Antifuse OTP, 0.25 um CMOS |
| Configuration Device Required | No | No | No | No |
Ключевые отличия
- True non-volatile, instant-on operation (против SRAM FPGAs (e.g., Lattice XP2-class devices))
- Design-readback security (против A54SX16A-TQG100A)
- Footprint-compatible density migration (против A54SX32A-1TQG100I)
Заметки по проектированию
The A54SX16A is one-time programmable. Unlike SRAM FPGAs, a programming error or late design change permanently consumes the device, so complete functional simulation, timing closure, and (ideally) a programmed-sample system validation before committing production quantities. Order a small engineering lot for validation builds, and keep the exact speed-grade suffix consistent between validation and production - timing reports from a grade-2 device do not guarantee closure on a standard-grade part.
Antifuse FPGAs have very low static current because there is no configuration RAM to hold, but dynamic power still scales with switching activity and I/O count. Budget I/O termination power separately: with up to 81 user I/O driving parallel buses, resistively terminated lines can dominate the power budget. Decouple VCC and VCCI banks with 0.1 uF ceramics per pin group plus bulk capacitance, and verify the supply sequencing of mixed-voltage I/O banks against the SX-A family datasheet electrical tables.
The 100-TQFP leadframe has 0.5 mm pitch leads - use a proven TQFP-100 land pattern with solder-mask-defined pads and inspect with AOI or X-ray for bridging on reflow. Keep unused user I/O configured per the Libero software recommendations (inputs with pull-down or grounded outputs) to avoid floating-node contention. Route clocks on short, direct traces; the SX-A routing fabric provides dedicated low-skew clock resources that should be matched with clean board-level clock entry.
Информация о соответствии
RoHS Compliant and Lead Free per A54SX16A-TQG100 datasheet specification summary (digichip) and distributor listings. Automotive-qualified builds exist in the family via A-suffix parts. REACH and halogen-free status not stated in provided data.
