ATMEGA808-AUR - 8-Bit AVR MCU 20MHz 8KB Flash | Microchip
MPN: ATMEGA808-AUR ✓ فعالATMEGA808-AUR جائزہ
A microcontroller (MCU) is a single integrated circuit that combines a processor core, program memory (Flash), data memory (SRAM), non-volatile EEPROM, and peripherals such as timers, USART, SPI, I2C and ADC on one chip. Microcontrollers form the lowest layer of the embedded systems hierarchy: MCU -> embedded processor -> system-on-chip, and are the building blocks of virtually every electronic product.
Key features of the ATMEGA808-AUR include a 20 MHz maximum clock frequency with functionality maintained down to 1.8V, 8 KB of on-chip In-System Reprogrammable Flash organized with a 16-bit data width (AVR instructions are 16 or 32 bits wide), 1 KB of SRAM, and 256 bytes of Data EEPROM. The device also carries Functional Safety (FuSa) documentation support per Microchip's product listing, making it attractive for safety-relevant industrial designs.
The megaAVR 0-series uses Microchip's latest Core Independent Peripherals (CIPs), allowing peripherals such as timers and comparators to operate without CPU intervention, which reduces interrupt latency and software complexity. The AVR RISC architecture executes most instructions in a single cycle, and the hardware multiplier enables efficient 8x8 arithmetic for control loops and lightweight DSP tasks.
Typical applications include industrial automation and sensor nodes, motor control and power conversion, home appliances, and general-purpose embedded control where 8 KB of Flash is sufficient. The 32-pin TQFP offers 25+ GPIO and a 7x7 mm footprint suited to compact two- or four-layer boards.
Design consideration: Flash programming and debugging use the single-wire UPDI interface on pin PA0, so reserve UPDI access on your PCB for in-system programming.
This page synthesizes verified distributor pricing, same-family drop-in alternatives, and practical design notes not consolidated in the manufacturer datasheet. Pricing references are as of 2026-09-18.
کے لیے ڈراپ اِن متبادل ATMEGA808-AUR — یکساں پیکیج، پن سے پن مطابقت پذیر۔ مختلف پیکیج والے پرزے جن کے لیے PCB دوبارہ کام درکار ہو، شامل نہیں ہیں۔
اس سیریز میں مختلف ورژن
اسی سیریز کے ماڈلز جو ڈراپ اِن مطابقت رکھتے ہیں ATMEGA808-AUR (یکساں فارم فیکٹر اور فٹ پرنٹ) — میں مختلف Series, Packaging, Peripherals, Core Processor, Programming Interface.
ATMEGA1608-AUR
✅ ڈراپ-اِن ⚠️ تفصیلات غیر تصدیق شدہقیمت کے لیے رابطہ کریں
ڈیٹا شیٹ دیکھیں →ATMEGA3208-AUR
✅ ڈراپ-اِن ⚠️ تفصیلات غیر تصدیق شدہقیمت کے لیے رابطہ کریں
ڈیٹا شیٹ دیکھیں →ATMEGA4808-AUR
✅ ڈراپ-اِن ⚠️ تفصیلات غیر تصدیق شدہقیمت کے لیے رابطہ کریں
ڈیٹا شیٹ دیکھیں →ATMEGA808-AF
✅ ڈراپ-اِن ⚠️ تفصیلات غیر تصدیق شدہ📋 حوالہ جاتی متبادل (کیٹلاگ میں نہیں)
ATMEGA808-AUR زیادہ سے زیادہ ریٹنگز اور برقی خصوصیات
| Core Processor | AVR (8-bit RISC with hardware multiplier) |
| Core Size | 8-bit |
| Series | megaAVR 0 |
| زیادہ سے زیادہ کلاک فریکوئنسی | 20 MHz |
| Flash Program Memory | 8 KB (8K x 8) |
| SRAM Data Memory | 1 KB |
| EEPROM | 256 bytes |
| Minimum Operating Voltage | 1.8 V |
| پیکیج | 32-TQFP (7x7 mm) |
| ماؤنٹنگ ٹائپ | Surface Mount |
| Functional Safety Support | FuSa (Functional Safety) documentation |
| Programming Interface | UPDI (single-wire) |
| آپریٹنگ درجہ حرارت | -40C to +85C (industrial, A-grade suffix) |
| Packaging | Tape and Reel (R suffix) |
| پنز کی تعداد | 32 |
| Peripherals | Core Independent Peripherals (CIPs): timers, USART, SPI, I2C, ADC |
ATMEGA808-AUR 32-tqfp (7x7 mm) پن کنفیگریشن گائیڈ
ATMEGA808-AUR (32-tqfp (7x7 mm) پیکیج) کے لیے پن کنفیگریشن۔ اس ڈیجیٹل IC میں GPIO، کمیونیکیشن انٹرفیس (UART، SPI، I2C) اور پاور پنز شامل ہیں۔ متبادل پن فنکشنز اور کنفیگریشن آپشنز کے لیے مینوفیکچرر کے ڈیٹا شیٹ سے رجوع کریں۔ ایمبیڈڈ سسٹم ڈیزائن اور PCB لے آؤٹ کے لیے ضروری۔
کے لیے تفصیلی پن آؤٹ ڈیٹا دستیاب نہیں ATMEGA808-AUR.
رجوع کریں ڈیٹا شیٹ مکمل پن کنفیگریشن کے لیے۔
عام استعمالات
ATMEGA808-AUR کے لیے موزوں ہے 6 ایپلیکیشنs: Industrial Automation and Sensor Nodes, Home Appliances and White Goods, Battery-Powered Portable Devices, LED Lighting and Dimming Control, Motor Control (Small Fans, Pumps, Tools), IoT Edge Nodes and Wired Gateways.
Industrial Automation and Sensor Nodes
The ATMEGA808-AUR fits industrial sensor nodes and small automation endpoints because its -40C to +85C industrial temperature rating, 1.8V minimum supply and Core Independent Peripherals allow reliable unattended operation. The 20 MHz AVR core with hardware multiplier handles filtering and scaling math for ADC data, while timers and the USART/SPI/I2C peripherals stream measurements to a PLC or gateway. With 8 KB Flash and 1 KB SRAM, a Modbus or simple protocol slave plus calibration logic fits comfortably. Its 32-TQFP 7x7 mm footprint keeps node PCBs compact, and FuSa documentation support eases safety assessments in machinery subsystems.
تجویز کردہ
Home Appliances and White Goods
In appliances such as fans, small pumps, coffee machines and cooker controls, the ATMEGA808-AUR provides the classic 8-bit MCU profile: low cost (about $1.09-$1.63 at 2026-09-18 distributor pricing), robust industrial temperature range, and enough 8 KB Flash for UI logic, relay sequencing and sensor monitoring. The hardware multiplier supports basic PID temperature loops, and Core Independent Peripherals keep PWM and timing running with minimal CPU load for responsive control. The 32-TQFP package provides sufficient GPIO for keys, LEDs and loads while remaining hand-solderable for service; Tape and Reel (-AUR) packaging suits high-volume SMT appliance assembly lines.
تجویز کردہ
Battery-Powered Portable Devices
The ATMEGA808-AUR suits battery-powered products because the megaAVR 0-series is specified to operate down to 1.8V, allowing direct use of two alkaline cells or a single Li-ion cell through a simple regulator. With only 8 KB Flash and 1 KB SRAM, the part keeps active logic small, and peripherals can run without the CPU to minimize wake latency. Typical uses include portable meters, remote controls and tracking tags. Designers should use the datasheet power-management registers (sleep modes) to reach the lowest standby current, and note the 20 MHz full-speed rating applies at higher supply voltages per the frequency-voltage derating curve in datasheet DS40002172C.
تجویز کردہ
LED Lighting and Dimming Control
For LED drivers and dimming controllers, the ATMEGA808-AUR offers multiple timers whose PWM outputs can drive MOSFET gate stages directly through Core Independent Peripherals, sustaining dimming without CPU intervention. The 20 MHz clock resolution supports flicker-free PWM frequencies above 1 kHz even at 8-bit resolution, and the hardware multiplier eases gamma-correction lookups. The 8 KB Flash stores dimming curves, DALI-style command handlers or touch-decision logic, while the industrial -40C to +85C rating suits enclosed luminaires. The 32-TQFP footprint with generous GPIO handles PWM, zero-cross detection and user interfaces on one chip.
تجویز کردہ
Motor Control (Small Fans, Pumps, Tools)
The ATMEGA808-AUR supports basic brushed-DC and small BLDC motor control: its hardware multiplier accelerates PID and commutation math at 20 MHz, and timer PWM channels plus analog comparator peripherals form the core of a six-step or scalar control loop. The 1 KB SRAM accommodates control-state variables and fault logs, while 8 KB Flash holds the control firmware plus protection logic. For closed-loop sensorless FOC with heavy arithmetic, engineers should step up to a same-package, pin-compatible family member with more Flash. The industrial temperature rating and FuSa documentation support make it viable for power-tool and appliance safety reviews.
تجویز کردہ
IoT Edge Nodes and Wired Gateways
As an IoT edge node front-end, the ATMEGA808-AUR collects sensor data over I2C/SPI and forwards it via USART to a wireless module or Ethernet gateway. Core Independent Peripherals let timers and communication interfaces service routine traffic without waking the CPU, reducing power in duty-cycled designs, while the 20 MHz AVR core preprocesses packets using its hardware multiplier for checksums and scaling. The 8 KB Flash and 1 KB SRAM fit a lightweight protocol handler; designs needing TLS or larger stacks should pair the MCU with a companion connectivity module rather than upgrading code space. The 32-TQFP package and UPDI interface simplify in-field reprogramming via a single-wire header.
تجویز کردہ
تجویز کردہ پروڈکٹس کا خلاصہ
کے لیے انجینئرنگ ریفرنس ڈیٹا ATMEGA808-AUR — موازنہ، ڈیزائن رہنمائی، اور تعمیل کی معلومات۔
انتخاب کی گائیڈ
متبادلات کے ساتھ موازنہ
| پیرامیٹر | یہ پروڈکٹ | ATMEGA1608-AUR | ATMEGA3208-AUR | ATMEGA4808-AUR |
|---|---|---|---|---|
| Brand | Microchip Technology | Microchip Technology | Microchip Technology | Microchip Technology |
| Package | 32-TQFP (7x7 mm) | 32-TQFP (7x7 mm) - same | 32-TQFP (7x7 mm) - same | 32-TQFP (7x7 mm) - same |
| Maximum Clock Frequency | 20 MHz | 20 MHz | 20 MHz | 20 MHz |
| Minimum Operating Voltage | 1.8 V | 1.8 V | 1.8 V | 1.8 V |
| Operating Temperature | -40C to +85C | -40C to +85C | -40C to +85C | -40C to +85C |
اہم امتیازی خصوصیات
- Lowest-cost 32-pin megaAVR 0-series member (بمقابلہATMEGA1608-AUR)
- Functional Safety (FuSa) documentation support (بمقابلہATMEGA808-AU (tray variant))
- Pin-compatible upgrade path within the same footprint (بمقابلہATMEGA4808-AUR)
ڈیزائن نوٹس
Reserve the single-wire UPDI interface (PA0) on a 3-pin header (UPDI, VDD, GND) on every ATMEGA808-AUR board. Unlike legacy AVR parts, the megaAVR 0-series uses UPDI for both programming and debugging, and losing access to this pin means the MCU cannot be reprogrammed in-system. A standard 1x3 2.54 mm header costs pennies and enables factory programming with tools such as Microchip's SNAP or the open-source pyupdi approach.
The ATMEGA808-AUR is specified to run down to 1.8V, but full 20 MHz operation is only valid within the frequency-versus-voltage derating curve in datasheet DS40002172C. If your design runs at 1.8-2.7V, reduce the clock accordingly or enable the internal oscillator scaling. Decouple each VDD pin with 100 nF ceramic capacitors placed within 2-3 mm of the pin, plus one bulk 4.7-10 uF capacitor near the supply entry. Verify brown-out detector settings for battery applications.
When substituting upward within the family (ATMEGA1608/3208/4808 in the same TQFP-32), the pinout and peripheral map are identical, but EEPROM sizes and Flash wait states differ - recompile and re-verify rather than flashing the same hex. Also note the 'R' suffix denotes Tape and Reel: if your contract manufacturer requires reel packaging for SMT lines, ordering the tray (-AU) variant will add handling steps. Confirm packaging code on purchase orders to avoid line-side shortages.
تعمیل کی معلومات
Compliance status not stated in the provided verified web data. Microchip standard production parts are typically RoHS-compliant, but confirm via the official Microchip product page or Environmental datasheet before specifying.
