PI7C9X9208SLFDE - 8-Ch Video Decoder Bridge | Diodes
料号： PI7C9X9208SLFDE ✗ 停产| 数量 | 单价 | 小计 |
|---|---|---|
| 1 | $0 | $0.00 |
| 10 | $0 | $0.00 |
| 100 | $0 | $0.00 |
| 500 | $0 | $0.00 |
| 1,000 | $0 | $0.00 |
PI7C9X9208SLFDE 概述
A video decoder bridge is an interface IC that receives digital video streams and associated audio or control data, converts or routes those streams into a system-facing interface, and helps bridge legacy display or multimedia paths to PCIe-based host systems. In the product hierarchy, this component belongs to video processing and interface ICs, with PCIe connectivity as its host-facing transport. It is intended for systems requiring eight-channel video/audio decoding rather than a general-purpose display controller.
The PI7C9X9208SLFDE is specifically associated with PCIe eight-channel video/audio decoder functionality. Its LFDE ordering suffix is supplied exactly as shown by the verified distributor records, while the package evidence identifies a 128-pin LQFP. The supplied sources do not state whether the part is currently active, whether it is obsolete, or whether a particular lifecycle designation applies. It also does not provide verified pricing, stock, lead time, or a complete set of electrical limits.
Typical design use is an embedded video system, digital signage controller, video capture appliance, or PCIe expansion card where multiple decoded video/audio channels must be transferred through a PCIe interface. The decoder should be validated against the host PCIe topology, display timing, audio routing, reference clock, and board-level signal-integrity requirements. Because the verified data does not specify those details, engineers should consult the manufacturer datasheet before finalizing clocking, lane configuration, termination, or firmware assumptions.
The most important design consideration is to avoid treating distributor search snippets as a substitute for the complete datasheet. In particular, verify the supported input formats, output interface, electrical timing, reset requirements, power rails, package drawing, exposed-pad treatment, and absolute maximum ratings. PCB layout should preserve high-speed signal return paths and provide the required decoupling and grounding according to the complete manufacturer documentation.
This page consolidates verified distributor identity, package information, sourcing links, and the available cross-reference context. It intentionally distinguishes confirmed facts from unavailable specifications rather than filling engineering gaps with assumptions.
PI7C9X9208SLFDE 最大额定值与电气特性
| Product Type | PCIe eight-channel video/audio decoder bridge IC |
| Manufacturer | Diodes Incorporated |
| Host Interface | PCIe |
| Video Channel Count | 8 channels |
| Package Type | 128-LQFP |
| Package Dimensions | 14 mm x 14 mm |
| Package Family | LQFP surface-mount package |
| 安装类型 | Surface mount |
| 引脚数量 | 128 pins |
| RoHS 状态 | Compliant according to the IC Components Limited distributor listing |
PI7C9X9208SLFDE lqfp surface-mount package 引脚配置指南
PI7C9X9208SLFDE（lqfp surface-mount package 封装）的引脚配置。 该功率器件具有栅极、漏极和源极端子。对于无极性封装，请参阅制造商数据手册以了解确切的引脚 1 方向和封装尺寸细节。常见应用包括电源设计、电机驱动和负载开关。
暂无详细引脚数据： PI7C9X9208SLFDE.
请参阅 数据手册 以查看完整引脚配置。
典型应用
PI7C9X9208SLFDE 适用于 7 应用s: PCIe Video Capture Card, Industrial Machine Vision, Digital Signage Controller, Broadcast Monitoring Equipment, Video Test and Measurement, PCIe Expansion System, Medical Imaging Acquisition.
PCIe Video Capture Card
The PI7C9X9208SLFDE fits a PCIe capture architecture that must handle eight video or video/audio decoding channels near the host interface. Its verified identity as an eight-channel PCIe video/audio decoder makes it relevant to multi-camera, industrial inspection, broadcast, and test systems, but the exact input formats and host lane configuration are not supplied. The design must confirm clocking, channel multiplexing, PCIe reference requirements, power rails, and signal integrity against the full datasheet before PCB release.
推荐
Industrial Machine Vision
An eight-channel video decoder bridge can be useful in industrial machine-vision equipment that receives multiple synchronized video streams from cameras or sensors. The verified distributor description supports the channel-count positioning, while unresolved details include supported resolutions, frame rates, sync architecture, and PCIe endpoint behavior. Engineers should treat the part as a candidate only after checking signal timing, reference-clock requirements, thermal exposure, and deterministic channel latency in the complete manufacturer documentation.
推荐
Digital Signage Controller
PI7C9X9208SLFDE may be considered for a digital-signage controller that receives multiple decoded video/audio streams and transfers them toward a PCIe-based processing engine. The verified evidence does not specify supported display formats, audio interfaces, scaling, color depth, or synchronization, so those features cannot be assumed. A practical design must compare the source and destination timing, validate PCIe lane requirements, and provide clean power and return paths for high-speed signals.
推荐
Broadcast Monitoring Equipment
A multi-channel decoding bridge can support broadcast-monitoring equipment that needs to ingest several video/audio streams for analysis, recording, or display. The verified target listing establishes eight-channel PCIe decoding but does not provide standards coverage, resolution limits, latency, or audio synchronization specifications. Use the device only after confirming those requirements, especially if the system depends on deterministic timing or multiple channels that must be locked together.
推荐
Video Test and Measurement
The eight-channel decoder function can be relevant in video test equipment used to bring multiple streams into a measurement or analysis system. The supplied sources do not identify test-pattern support, loopback behavior, timing tolerances, or electrical input ranges, so those capabilities must be verified before selecting the IC. A practical implementation should reserve controlled clocks, robust grounding, and accessible test points while keeping sensitive high-speed routes short and properly referenced.
推荐
PCIe Expansion System
The PI7C9X9208SLFDE can be evaluated as the video-facing element of a PCIe expansion system in which decoded channels must reach a host processor or another digital subsystem. Its confirmed package identity makes board-level sourcing easier, but missing power, clock, pin, and timing data prevent a definitive architecture recommendation. Confirm host lane width, connector requirements, reference-clock distribution, reset sequencing, and signal-loss tolerances in the manufacturer documentation.
推荐
Medical Imaging Acquisition
Multi-channel video decoding may be considered in specialized medical-imaging acquisition systems, but the supplied data does not establish medical qualification, image-format support, latency guarantees, or isolation requirements. PI7C9X9208SLFDE should therefore be treated only as a candidate interface IC for non-safety-critical acquisition research until its complete specifications are reviewed. Any medical use requires separate system-level risk, electrical-safety, privacy, and validation work beyond this component listing.
推荐
推荐产品汇总
工程参考数据： PI7C9X9208SLFDE ——对比、设计指导和合规信息。
选型指南
与替代料对比
| 参数 | 本产品 |
|---|---|
| Package | 128-LQFP |
| Brand | Diodes Incorporated |
| Function | PCIe eight-channel video/audio decoder bridge |
| Host Interface | PCIe |
| Video Channels | 8 channels |
| Package Size | 14 mm x 14 mm |
关键差异点
- Eight-channel decoding position （对比 PI7C9X2G404SVAFDEEX)
- PCIe-specific positioning （对比 PI7C9X2G404SVAFDEEX)
- Documented package association （对比 PI7C9X2G404SVAFDEEX)
设计说明
The available evidence confirms PCIe video/audio decoding and a 128-LQFP package, but it does not provide pin-level signal definitions or timing tables. Before routing, obtain the manufacturer pinout and identify every high-speed differential or single-ended path. Keep traces short where the interface allows, provide continuous return paths, and keep connector, clock, and decoder interfaces away from noisy switching nodes.
Power-rail values and current consumption are not present in the verified data, so no capacitor value or thermal estimate should be inferred from the distributor descriptions. After obtaining the datasheet, calculate the worst-case supply dissipation using the actual rail voltages and load currents, then place the specified decoupling capacitors directly at the relevant power pins and preserve adequate ground-plane continuity.
The most consequential mistake is treating the target as a generic video decoder or assuming that a similar PCIe bridge is interchangeable. The exact supported video formats, audio path, clocking, reset behavior, configuration method, electrical limits, and lifecycle status are not supplied. Require a complete datasheet and a written cross-reference check before schematic, firmware, or PCB sign-off.
合规信息
The IC Components Limited listing identifies the part as RoHS compliant. The supplied data does not verify REACH, lead-free status, halogen-free status, conflict-minerals status, or automotive qualification.
