TFA9865 - 7W CoolPWM Smart Class-D Amplifier | Goodix
料号： TFA9865 ✓ 量产中| 数量 | 单价 | 小计 |
|---|---|---|
| 1 | $1.85 | $1.85 |
| 10 | $1.62 | $16.20 |
| 100 | $1.4 | $140.00 |
| 500 | $1.18 | $590.00 |
| 1,000 | $0.98 | $980.00 |
TFA9865 概述
A Class-D audio amplifier is a switching-mode power stage that converts a PWM or PDM waveform into a high-efficiency audio output, driving a loudspeaker directly through an LC reconstruction filter. Within the broader audio IC taxonomy, the TFA9865 sits in the smart amplifier sub-category of power management and signal chain ICs, sitting alongside traditional Class-AB amplifiers but achieving far higher efficiency (typically >85 %) and lower thermal dissipation. Goodix's first-generation CoolPWM architecture is a proprietary, fully digital modulation scheme that breaks away from conventional Class-D topologies to minimize EMI and audible idle-channel noise.
Key specifications include 7 W peak output into a typical 4 ohm or 8 ohm speaker load, an idle-channel noise floor of less than 7 uV, integrated DSP-based speaker protection algorithms, I2C/TDM control interface, and a small WLCSP footprint enabling direct placement adjacent to the smartphone or tablet speaker. Compared with discrete analog Class-D solutions, the TFA9865 reduces BOM count by integrating gate drivers, MOSFET power stage, and digital modulation in a single die.
The CoolPWM digital architecture leverages advanced manufacturing processes to deliver high audio performance with very low power consumption. Built-in adaptive excursion control and thermal protection extend the usable loudness envelope of small speakers without causing voice-coil damage. This makes the device well suited to handset, tablet, and portable speaker applications where designers must push SPL limits within tight thermal budgets.
Typical applications include smartphone and tablet loudspeaker amplification, portable Bluetooth speakers, wearable audio devices, and notebook/laptop speakers. The part is commonly paired with Goodix or third-party audio CODECs and digital microphone pre-processors to form a complete mobile audio playback chain.
When designing with the TFA9865, pay close attention to PCB layout of the LC output filter, the placement of the bootstrap capacitor, and the thermal pad connection. Use a 4-layer stack-up with a solid ground plane directly beneath the part to minimize EMI coupling into adjacent RF circuits.
This page synthesizes distributor pricing, drop-in alternatives, application examples, and practical design notes not found in the manufacturer product brief.
直接替换替代料： TFA9865 ——相同封装，引脚兼容。需要 PCB 改动的不同封装料号已排除。
快速对比工具——选择替代料号进行并排对比：
TFA9862
✅ 直接替换 ⚠️ 规格未核验📋 参考替代料（不在目录中）
TFA9860
✅ 直接替换 ⚠️ 规格未核验📋 参考替代料（不在目录中）
MAX98304
✅ 直接替换📋 参考替代料（不在目录中）
TFA9865 最大额定值与电气特性
| 拓扑 | Class-D Smart Amplifier |
| Architecture | CoolPWM (fully digital) |
| Peak Output Power | 7 W |
| Idle-Channel Noise Floor | <7 uV |
| 封装 | WLCSP (2.2 x 2.2 mm) |
| 通道数 | Mono (single-channel Class-D) |
| Control Interface | I2C / TDM |
| Built-in Protection | Thermal, excursion, short-circuit |
| Target Load | 4 ohm / 8 ohm speaker |
| 安装类型 | Surface Mount (WLCSP) |
| MSL 等级 | 1 (unlimited floor life) |
| RoHS 状态 | Compliant |
| Lead-Free | Yes |
| 无卤 | Yes |
| Target Application | Smartphone, tablet, portable speaker |
TFA9865 wlcsp (2.2 x 2.2 mm) 引脚配置指南
TFA9865（wlcsp (2.2 x 2.2 mm) 封装）的引脚配置。 该模拟元件具有输入、输出和电源引脚。请参阅制造商数据手册以了解失调调零、补偿和使能引脚配置。适用于信号调理和放大器电路。
暂无详细引脚数据： TFA9865.
请参阅 数据手册 以查看完整引脚配置。
典型应用
TFA9865 适用于 6 应用s: Smartphone Loudspeaker Amplification, Tablet and 2-in-1 PC Audio, Portable Bluetooth Speaker, Wearable Audio Devices, Notebook and Ultrabook Speakers, AI Assistant and Smart Home Audio.
Smartphone Loudspeaker Amplification
The TFA9865 is purpose-built for smartphone main-speaker playback, where its 7 W peak output and <7 uV noise floor enable louder, cleaner hands-free and music reproduction. According to the Goodix product brief, the CoolPWM architecture's integrated adaptive excursion control allows designers to push SPL limits without damaging the small (typically 4 ohm or 8 ohm) handset speaker. The 2.2x2.2 mm WLCSP footprint lets the IC sit adjacent to the speaker on the main board, minimizing trace-induced EMI into the RF power amplifier chain.
推荐
Tablet and 2-in-1 PC Audio
Tablets and convertible laptops demand higher SPL than phones because their speakers are placed farther from the listener. The TFA9865's 7 W peak output comfortably drives a pair of stereo speakers in bridged configuration, and the <7 uV noise floor preserves audio fidelity for video playback and conference calls. Per the Goodix product page, the integrated thermal protection prevents shutdown during sustained high-volume movie playback, while the small WLCSP package preserves precious PCB area in slim tablet chassis designs.
推荐
Portable Bluetooth Speaker
Battery-powered Bluetooth speakers benefit from the TFA9865's high-efficiency Class-D topology, which minimizes quiescent current and extends playback time per charge. According to the Goodix product brief, the CoolPWM architecture reduces idle power draw compared to conventional Class-D amplifiers, while the 7 W peak output drives small full-range drivers with authority. Built-in short-circuit and over-temperature protection allow designers to use small PCB copper pours, cutting BOM cost in consumer audio products.
推荐
Wearable Audio Devices
Smart watches, AR/VR headsets, and fitness earbuds require the smallest possible audio amplifier footprint. The TFA9865's 2.2x2.2 mm WLCSP package enables direct integration into space-constrained wearable designs where every square millimeter matters. Per the audioXpress coverage, the CoolPWM digital architecture delivers clean audio from a tiny speaker, while integrated protection prevents voice-coil damage during high-SPL notification tones or voice-assistant playback in ear-worn form factors.
推荐
Notebook and Ultrabook Speakers
Modern notebooks place speakers behind the keyboard, requiring careful EMI management to avoid coupling into Wi-Fi/Bluetooth antennas. The TFA9865's CoolPWM modulation is engineered for low EMI emissions, allowing placement near RF antennas without extensive shielding. According to the Goodix product brief, the 7 W output is sufficient for thin-notebook bottom-firing speakers, while the integrated thermal shutdown prevents overheating during sustained conference-call or movie playback sessions.
推荐
AI Assistant and Smart Home Audio
Voice-first smart home hubs, smart displays, and AI assistant devices require always-on audio playback that is clean during quiet moments and powerful during music or alarms. The TFA9865's <7 uV idle-channel noise floor ensures no audible hiss between voice prompts, while the 7 W peak supports music playback and notification tones. Per Goodix, the I2C/TDM digital interface simplifies integration with system-on-chips running voice assistants, allowing dynamic volume and EQ control without external DAC stages.
推荐
推荐产品汇总
工程参考数据： TFA9865 ——对比、设计指导和合规信息。
选型指南
与替代料对比
| 参数 | 本产品 | TFA9862 | TFA9860 | MAX98304 |
|---|---|---|---|---|
| Brand | Goodix | Goodix | Goodix | Analog Devices |
| Package | WLCSP (2.2x2.2 mm) | WLCSP - same family | WLCSP - same family | WLCSP-12 - same package type |
| Architecture | CoolPWM Class-D (digital) | CoolPWM Class-D | CoolPWM Class-D | Analog Class-D |
| Peak Output Power | 7 W | ~5 W | ~4 W | 3.2 W |
| Idle-Channel Noise | <7 uV | <7 uV | <10 uV | ~20 uV |
| Control Interface | I2C / TDM | I2C / TDM | I2C / TDM | I2S |
| Integrated Protection | Thermal, excursion, short-circuit | Thermal, excursion, short-circuit | Thermal, excursion | Thermal, short-circuit |
| RoHS Compliance | Yes | Yes | Yes | Yes |
关键差异点
- Highest peak output power in the CoolPWM family （对比 TFA9862)
- Coolest idle noise floor in the smart-amp category （对比 MAX98304)
- Smallest package footprint in 7 W class （对比 MAX98304)
设计说明
Use a 4-layer PCB stack-up with a continuous solid ground plane directly beneath the TFA9865 WLCSP footprint. This minimizes EMI coupling into adjacent RF circuits and provides a low-impedance thermal path. Place the LC output filter within 5 mm of the OUT pins to limit switching-current loop area, and keep the bootstrap capacitor return trace short and direct to ground.
Estimated: at 7 W peak into 4 ohm and 90% efficiency, the TFA9865 dissipates approximately 0.7 W internally. The WLCSP package relies entirely on PCB copper for heat sinking - allocate at least 25 mm^2 of 1 oz copper on the top layer connected to the die thermal pad, plus additional inner-plane copper stitched with thermal vias, to keep junction temperature within the 125 C limit under worst-case music-playback duty cycles.
Do not assume the TFA9865 is a drop-in replacement for any non-Goodix Class-D amplifier despite similar naming. The CoolPWM I2C/TDM interface differs from analog PWM or I2S inputs, and the WLCSP pinout is unique to the TFA98xx family. Confirm register map, reference schematic, and LC filter component values against the official Goodix reference design before PCB fabrication.
合规信息
RoHS and lead-free per Goodix product page. AEC-Q100 not applicable - TFA9865 is targeted at consumer mobile/portable audio, not automotive.
