ADM483JR vs ADM485ARZ مقارنة
مقارنة تفصيلية جنبًا إلى جنب لـ ADM483JR بواسطة Analog Devices و ADM485ARZ بواسطة Analog Devices. قارن المواصفات الرئيسية والمعلمات الكهربائية والتغليف وحالة دورة الحياة والأسعار والتوافر لتحديد أفضل مكوّن لمتطلبات تصميمك.
Analog Devices
ADM485ARZ - 5V 5Mbps Half-Duplex RS-485/RS-422 Transceiver | Analog Devices (Tape & Reel)
ADM485ARZ ✓ نشطمقارنة المواصفات
| المعامل | ADM483JR | ADM485ARZ |
|---|---|---|
| العلامة التجارية | Analog Devices | Analog Devices |
| الفئة | Interface ICs | Interface ICs |
| حالة دورة الحياة | نشط | نشط |
| Product Type | Low-power differential line transceiver | — |
| جهد التغذية | 5 V | 5 V (single supply) |
| معدل البيانات | Up to 250 kbps | 5 Mbps (max) |
| Communication Standard | EIA RS-485/RS-422 compliant | — |
| Operating Mode | Half-duplex | — |
| Typical Operating Supply Current | 120 µA | — |
| Shutdown Supply Current | 100 nA | — |
| Bus Common-Mode Range | -7 V to +12 V | — |
| Maximum Transceivers on One Bus | 32 transceivers | — |
| Output State When Disabled or Powered Off | High impedance | — |
| Slew Rate | Limited for low EMI | — |
| Protection | Thermal shutdown and short-circuit protection | — |
| Pin Compatibility | Pin-compatible with MAX483 | — |
| نطاق درجة حرارة التشغيل | -40°C to +85°C | -40 C to +85 C |
| العلبة | 8-lead SOIC, 3.90 mm width | SOIC-8 (SO-8) / SO-8 |
| نوع التركيب | Surface mount | Surface Mount |
| حالة RoHS | [DATA_NEEDED: RoHS status] | Compliant |
| REACH Status | [DATA_NEEDED: REACH status] | Unaffected |
| AEC-Q100 Qualification | [DATA_NEEDED: AEC-Q100 qualification] | — |
| Type | — | Transceiver |
| Protocol | — | RS-422, RS-485 |
| Number of Drivers/Receivers | — | 1/1 |
| Duplex | — | Half |
| Receiver Hysteresis | — | [DATA_NEEDED: receiver hysteresis] |
| Common-Mode Range | — | -7 V to +12 V |
| Driver Differential Output | — | [DATA_NEEDED: VOD min/max] |
| ESD Protection | — | [DATA_NEEDED: ESD HBM rating] |
| مستوى MSL | — | 1 (Unlimited) |
| Compliance | — | ROHS3 Compliant |
| Enable Pins | — | Yes (DE driver enable, RE receiver enable, active-low/GPIO logic) |