ADM483JR vs ADM485ARZ Perbandingan
Perbandingan bersamaan detil ADM483JR dari Analog Devices dan ADM485ARZ dari Analog Devices. Bandingkan spesifikasi penting, parameter listrik, pengemasan, status cycle, harga, dan ketersediaan untuk menentukan komponen terbaik untuk kebutuhan desain Anda.
Analog Devices
ADM485ARZ - 5V 5Mbps Half-Duplex RS-485/RS-422 Transceiver | Analog Devices (Tape & Reel)
ADM485ARZ ✓ AktifPerbandingan Spesifikasi
| Parameter Umum | ADM483JR | ADM485ARZ |
|---|---|---|
| Merek | Analog Devices | Analog Devices |
| Kategori | Interface ICs | Interface ICs |
| Status Lingkungan Hidup | Aktif | Aktif |
| Product Type | Low-power differential line transceiver | — |
| Tegangan Pemuat | 5 V | 5 V (single supply) |
| Laju Data | Up to 250 kbps | 5 Mbps (max) |
| Communication Standard | EIA RS-485/RS-422 compliant | — |
| Operating Mode | Half-duplex | — |
| Typical Operating Supply Current | 120 µA | — |
| Shutdown Supply Current | 100 nA | — |
| Bus Common-Mode Range | -7 V to +12 V | — |
| Maximum Transceivers on One Bus | 32 transceivers | — |
| Output State When Disabled or Powered Off | High impedance | — |
| Slew Rate | Limited for low EMI | — |
| Protection | Thermal shutdown and short-circuit protection | — |
| Pin Compatibility | Pin-compatible with MAX483 | — |
| Rentang Suhu Kerja | -40°C to +85°C | -40 C to +85 C |
| Paket | 8-lead SOIC, 3.90 mm width | SOIC-8 (SO-8) / SO-8 |
| Tipe Mounting | Surface mount | Surface Mount |
| Status RoHS | [DATA_NEEDED: RoHS status] | Compliant |
| REACH Status | [DATA_NEEDED: REACH status] | Unaffected |
| AEC-Q100 Qualification | [DATA_NEEDED: AEC-Q100 qualification] | — |
| Type | — | Transceiver |
| Protocol | — | RS-422, RS-485 |
| Number of Drivers/Receivers | — | 1/1 |
| Duplex | — | Half |
| Receiver Hysteresis | — | [DATA_NEEDED: receiver hysteresis] |
| Common-Mode Range | — | -7 V to +12 V |
| Driver Differential Output | — | [DATA_NEEDED: VOD min/max] |
| ESD Protection | — | [DATA_NEEDED: ESD HBM rating] |
| Level MSL | — | 1 (Unlimited) |
| Compliance | — | ROHS3 Compliant |
| Enable Pins | — | Yes (DE driver enable, RE receiver enable, active-low/GPIO logic) |