INA111BU vs INA114BU Comparison
Detailed side-by-side comparison of INA111BU by Texas Instruments and INA114BU by Texas Instruments. Compare key specifications, electrical parameters, packaging, lifecycle status, pricing, and availability to determine the best component for your design requirements.
Texas Instruments
INA111BU - 2 MHz FET-Input Instrumentation Amplifier | Texas Instruments
INA111BU ✓ ActiveSpecification Comparison
| Parameter | INA111BU | INA114BU |
|---|---|---|
| Brand | Texas Instruments | Texas Instruments |
| Category | Amplifier ICs | Amplifier ICs |
| Lifecycle Status | Active | Active |
| Product Type | Instrumentation amplifier | Low-cost, general-purpose precision instrumentation amplifier |
| Number of Amplifiers | 1 circuit | — |
| Input Transistor Type | FET-input | — |
| Gain-Bandwidth Product | 2 MHz | 1 MHz |
| Slew Rate | 17 V/us | 0.06 V/µs |
| Common-Mode Rejection Ratio | 106 dB | — |
| Input Bias Current | Less than 20 pA | — |
| Supply Voltage Range | 6 V to 18 V | 2.25 V to 18 V |
| Maximum Supply Voltage | 18 V | — |
| Operating Temperature Range | -40 C to +85 C | -40°C to +85°C |
| Package | 16-pin SOIC | 16-pin SOIC |
| Mounting Type | Surface mount | Surface mount |
| Input Protection | [DATA_NEEDED: input protection rating] | — |
| Input Offset Voltage | [DATA_NEEDED: input offset voltage] | 50 uV |
| Output Voltage Swing | [DATA_NEEDED: output voltage swing] | — |
| Gain Range | [DATA_NEEDED: gain range] | 1 to 10,000 |
| Gain-Setting Resistor | [DATA_NEEDED: gain-setting resistor] | — |
| Quiescent Current | [DATA_NEEDED: quiescent current] | — |
| Noise Density | [DATA_NEEDED: noise density] | — |
| RoHS Status | [DATA_NEEDED: RoHS status] | [DATA_NEEDED: RoHS compliance status] |
| REACH Status | [DATA_NEEDED: REACH status] | [DATA_NEEDED: REACH compliance status] |
| AEC-Q100 Qualification | Not applicable | — |
| Amplifier Type | — | Precision instrumentation amplifier |
| Architecture | — | Three-op-amp design |
| Number of Circuits | — | 1 circuit |
| Input Noise Density | — | 11 nV/√Hz |
| Typical Supply Current | — | 3 mA |
| Gain-Setting Method | — | One external resistor |
| Input Protection Range | — | ±40 V |
| Settling Time | — | 600 ns |