INA111BU vs INA114BU Pengandingan
Pengandingan Sisi Kiri Sisi Kanan Terperinci INA111BU disebabkan oleh Texas Instruments dan INA114BU disebabkan oleh Texas Instruments. Bandingkan spesifikasi utama, parameter elektrik, pakej, status kehidupan, harga, dan keupayaan untuk menentukan komponen terbaik untuk keperluan disenjaya anda.
Texas Instruments
INA111BU - 2 MHz FET-Input Instrumentation Amplifier | Texas Instruments
INA111BU ✓ AktifPengandingan Spesifikasi
| Parametr | INA111BU | INA114BU |
|---|---|---|
| Merek | Texas Instruments | Texas Instruments |
| Kategori | Amplifier ICs | Amplifier ICs |
| Status Lingkungan Hidup | Aktif | Aktif |
| Product Type | Instrumentation amplifier | Low-cost, general-purpose precision instrumentation amplifier |
| Number of Amplifiers | 1 circuit | — |
| Input Transistor Type | FET-input | — |
| Gain-Bandwidth Product | 2 MHz | 1 MHz |
| Slew Rate | 17 V/us | 0.06 V/µs |
| Common-Mode Rejection Ratio | 106 dB | — |
| Input Bias Current | Less than 20 pA | — |
| Supply Voltage Range | 6 V to 18 V | 2.25 V to 18 V |
| Maximum Supply Voltage | 18 V | — |
| Gambaran Suhu Operasi | -40 C to +85 C | -40°C to +85°C |
| Kemasan | 16-pin SOIC | 16-pin SOIC |
| Jenis Pemasangan | Surface mount | Surface mount |
| Input Protection | [DATA_NEEDED: input protection rating] | — |
| Input Offset Voltage | [DATA_NEEDED: input offset voltage] | 50 uV |
| Output Voltage Swing | [DATA_NEEDED: output voltage swing] | — |
| Gain Range | [DATA_NEEDED: gain range] | 1 to 10,000 |
| Gain-Setting Resistor | [DATA_NEEDED: gain-setting resistor] | — |
| Arus Dalam Tentera | [DATA_NEEDED: quiescent current] | — |
| Jisim Bising | [DATA_NEEDED: noise density] | — |
| Status RoHS | [DATA_NEEDED: RoHS status] | [DATA_NEEDED: RoHS compliance status] |
| REACH Status | [DATA_NEEDED: REACH status] | [DATA_NEEDED: REACH compliance status] |
| AEC-Q100 Qualification | Not applicable | — |
| Amplifier Type | — | Precision instrumentation amplifier |
| Architecture | — | Three-op-amp design |
| Number of Circuits | — | 1 circuit |
| Input Noise Density | — | 11 nV/√Hz |
| Typical Supply Current | — | 3 mA |
| Gain-Setting Method | — | One external resistor |
| Input Protection Range | — | ±40 V |
| Settling Time | — | 600 ns |