INA111BU vs INA114BU Karşılaştırma
Ayrıntılı yan yana karşılaştırma INA111BU tarafından Texas Instruments ve INA114BU tarafından Texas InstrumentsAnahtar özellikleri, elektriksel parametreleri, ambalajı, yaşam döngüsü durumu, fiyatlandırma ve mevcudiyeti karşılaştırarak tasarım gereksinimleriniz için en iyi bileşeni belirleyin.
Texas Instruments
INA111BU - 2 MHz FET-Input Instrumentation Amplifier | Texas Instruments
INA111BU ✓ AktifÖzellik Karşılaştırması
| Parametre | INA111BU | INA114BU |
|---|---|---|
| Marka | Texas Instruments | Texas Instruments |
| Kategori | Amplifier ICs | Amplifier ICs |
| Yaşam Döngüsü Durumu | Aktif | Aktif |
| Product Type | Instrumentation amplifier | Low-cost, general-purpose precision instrumentation amplifier |
| Number of Amplifiers | 1 circuit | — |
| Input Transistor Type | FET-input | — |
| Gain-Bandwidth Product | 2 MHz | 1 MHz |
| Slew Rate | 17 V/us | 0.06 V/µs |
| Common-Mode Rejection Ratio | 106 dB | — |
| Input Bias Current | Less than 20 pA | — |
| Supply Voltage Range | 6 V to 18 V | 2.25 V to 18 V |
| Maximum Supply Voltage | 18 V | — |
| İşletim Sıcaklığı Aralığı | -40 C to +85 C | -40°C to +85°C |
| Paket | 16-pin SOIC | 16-pin SOIC |
| Montaj Türü | Surface mount | Surface mount |
| Input Protection | [DATA_NEEDED: input protection rating] | — |
| Input Offset Voltage | [DATA_NEEDED: input offset voltage] | 50 uV |
| Output Voltage Swing | [DATA_NEEDED: output voltage swing] | — |
| Gain Range | [DATA_NEEDED: gain range] | 1 to 10,000 |
| Gain-Setting Resistor | [DATA_NEEDED: gain-setting resistor] | — |
| Durağan Akım | [DATA_NEEDED: quiescent current] | — |
| Gürültü Yoğunluğu | [DATA_NEEDED: noise density] | — |
| RoHS Durumu | [DATA_NEEDED: RoHS status] | [DATA_NEEDED: RoHS compliance status] |
| REACH Status | [DATA_NEEDED: REACH status] | [DATA_NEEDED: REACH compliance status] |
| AEC-Q100 Qualification | Not applicable | — |
| Amplifier Type | — | Precision instrumentation amplifier |
| Architecture | — | Three-op-amp design |
| Number of Circuits | — | 1 circuit |
| Input Noise Density | — | 11 nV/√Hz |
| Typical Supply Current | — | 3 mA |
| Gain-Setting Method | — | One external resistor |
| Input Protection Range | — | ±40 V |
| Settling Time | — | 600 ns |