SN65HVD12D vs SN65HVD77D Comparison

Detailed side-by-side comparison of SN65HVD12D by Texas Instruments and SN65HVD77D by Texas Instruments. Compare key specifications, electrical parameters, packaging, lifecycle status, pricing, and availability to determine the best component for your design requirements.

Texas Instruments
SN65HVD12D SN65HVD12D - 3.3V RS-485 Transceiver | Texas Instruments

SN65HVD12D - 3.3V RS-485 Transceiver | Texas Instruments

SN65HVD12D ✓ Active
Texas Instruments
SN65HVD77D SN65HVD77D - 3.3V 50Mbps Full-Duplex RS-485 | Texas Instruments

SN65HVD77D - 3.3V 50Mbps Full-Duplex RS-485 | Texas Instruments

SN65HVD77D ✓ Active

Specification Comparison

Parameter SN65HVD12D SN65HVD77D
Brand Texas Instruments Texas Instruments
Category RS-485/RS-422 Interface ICs
Lifecycle Status Active Active
Product Type Differential RS-422/RS-485 transceiver Full-duplex RS-485 transceiver
Supply Voltage 3.3 V —
Duplex Mode Half-duplex Full duplex
Supported Standards ANSI TIA/EIA-485-A and ISO 8482:1993 RS-485 and RS-422
Maximum Signaling Rate 1 Mbit/s —
Driver Configuration 3-state differential line driver —
Receiver Configuration Differential line receiver —
Transmitters per Device 1 —
Receivers per Device 1 —
Bus-Pin ESD Protection Exceeds 16 kV HBM —
Unit-Load Option 1/8 unit load, up to 256 nodes —
Operating Temperature Range -40°C to +85°C -40°C to 125°C
Package 8-pin SOIC 8-pin SOIC (D)
Mounting Type Surface mount Surface mount
Signal Type Balanced differential —
Power-Supply Architecture Single supply —
RoHS Status [DATA_NEEDED: RoHS status] Compliant
REACH Status [DATA_NEEDED: REACH status] —
AEC-Q100 Qualification [DATA_NEEDED: AEC-Q100 qualification status] —
Supply Voltage Range — 3.0 V to 3.6 V
Nominal Supply Voltage — 3.3 V
Maximum Data Rate — 50 Mbps
Number of Drivers — 1
Number of Receivers — 1
ESD Protection — ±12 kV IEC
Package Width — 3.90 mm
External Enable Controls — None
Driver Output Type — Differential
Receiver Output Type — Single-ended logic output
Low-Power Standby Current — Less than 5 µA when driver and receiver are disabled
Termination Requirement — External termination required

Datasheets & Resources

Browse All Products Create BOM Request Quote