SN65HVD12D vs SN65HVD77D Pengandingan
Pengandingan Sisi Kiri Sisi Kanan Terperinci SN65HVD12D disebabkan oleh Texas Instruments dan SN65HVD77D disebabkan oleh Texas Instruments. Bandingkan spesifikasi utama, parameter elektrik, pakej, status kehidupan, harga, dan keupayaan untuk menentukan komponen terbaik untuk keperluan disenjaya anda.
Texas Instruments
SN65HVD77D - 3.3V 50Mbps Full-Duplex RS-485 | Texas Instruments
SN65HVD77D ✓ AktifPengandingan Spesifikasi
| Parametr | SN65HVD12D | SN65HVD77D |
|---|---|---|
| Merek | Texas Instruments | Texas Instruments |
| Kategori | RS-485/RS-422 | Interface ICs |
| Status Lingkungan Hidup | Aktif | Aktif |
| Product Type | Differential RS-422/RS-485 transceiver | Full-duplex RS-485 transceiver |
| Tegangan Pemberi Arus | 3.3 V | — |
| Duplex Mode | Half-duplex | Full duplex |
| Supported Standards | ANSI TIA/EIA-485-A and ISO 8482:1993 | RS-485 and RS-422 |
| Maximum Signaling Rate | 1 Mbit/s | — |
| Driver Configuration | 3-state differential line driver | — |
| Receiver Configuration | Differential line receiver | — |
| Transmitters per Device | 1 | — |
| Receivers per Device | 1 | — |
| Bus-Pin ESD Protection | Exceeds 16 kV HBM | — |
| Unit-Load Option | 1/8 unit load, up to 256 nodes | — |
| Gambaran Suhu Operasi | -40°C to +85°C | -40°C to 125°C |
| Kemasan | 8-pin SOIC | 8-pin SOIC (D) |
| Jenis Pemasangan | Surface mount | Surface mount |
| Signal Type | Balanced differential | — |
| Power-Supply Architecture | Single supply | — |
| Status RoHS | [DATA_NEEDED: RoHS status] | Compliant |
| REACH Status | [DATA_NEEDED: REACH status] | — |
| AEC-Q100 Qualification | [DATA_NEEDED: AEC-Q100 qualification status] | — |
| Supply Voltage Range | — | 3.0 V to 3.6 V |
| Nominal Supply Voltage | — | 3.3 V |
| Maximum Data Rate | — | 50 Mbps |
| Number of Drivers | — | 1 |
| Number of Receivers | — | 1 |
| ESD Protection | — | ±12 kV IEC |
| Package Width | — | 3.90 mm |
| External Enable Controls | — | None |
| Driver Output Type | — | Differential |
| Receiver Output Type | — | Single-ended logic output |
| Low-Power Standby Current | — | Less than 5 µA when driver and receiver are disabled |
| Termination Requirement | — | External termination required |