SN65HVD12D vs SN65HVD77D Karşılaştırma
Ayrıntılı yan yana karşılaştırma SN65HVD12D tarafından Texas Instruments ve SN65HVD77D tarafından Texas InstrumentsAnahtar özellikleri, elektriksel parametreleri, ambalajı, yaşam döngüsü durumu, fiyatlandırma ve mevcudiyeti karşılaştırarak tasarım gereksinimleriniz için en iyi bileşeni belirleyin.
Texas Instruments
SN65HVD77D - 3.3V 50Mbps Full-Duplex RS-485 | Texas Instruments
SN65HVD77D ✓ AktifÖzellik Karşılaştırması
| Parametre | SN65HVD12D | SN65HVD77D |
|---|---|---|
| Marka | Texas Instruments | Texas Instruments |
| Kategori | RS-485/RS-422 | Interface ICs |
| Yaşam Döngüsü Durumu | Aktif | Aktif |
| Product Type | Differential RS-422/RS-485 transceiver | Full-duplex RS-485 transceiver |
| Besleme Gerilimi | 3.3 V | — |
| Duplex Mode | Half-duplex | Full duplex |
| Supported Standards | ANSI TIA/EIA-485-A and ISO 8482:1993 | RS-485 and RS-422 |
| Maximum Signaling Rate | 1 Mbit/s | — |
| Driver Configuration | 3-state differential line driver | — |
| Receiver Configuration | Differential line receiver | — |
| Transmitters per Device | 1 | — |
| Receivers per Device | 1 | — |
| Bus-Pin ESD Protection | Exceeds 16 kV HBM | — |
| Unit-Load Option | 1/8 unit load, up to 256 nodes | — |
| İşletim Sıcaklığı Aralığı | -40°C to +85°C | -40°C to 125°C |
| Paket | 8-pin SOIC | 8-pin SOIC (D) |
| Montaj Türü | Surface mount | Surface mount |
| Signal Type | Balanced differential | — |
| Power-Supply Architecture | Single supply | — |
| RoHS Durumu | [DATA_NEEDED: RoHS status] | Compliant |
| REACH Status | [DATA_NEEDED: REACH status] | — |
| AEC-Q100 Qualification | [DATA_NEEDED: AEC-Q100 qualification status] | — |
| Supply Voltage Range | — | 3.0 V to 3.6 V |
| Nominal Supply Voltage | — | 3.3 V |
| Maximum Data Rate | — | 50 Mbps |
| Number of Drivers | — | 1 |
| Number of Receivers | — | 1 |
| ESD Protection | — | ±12 kV IEC |
| Package Width | — | 3.90 mm |
| External Enable Controls | — | None |
| Driver Output Type | — | Differential |
| Receiver Output Type | — | Single-ended logic output |
| Low-Power Standby Current | — | Less than 5 µA when driver and receiver are disabled |
| Termination Requirement | — | External termination required |