SN65HVD12D vs SN65HVD77D Comparaison
Comparaison détaillée côte à côte de SN65HVD12D par Texas Instruments et SN65HVD77D par Texas Instruments. Comparez les spécifications clés, les paramètres électriques, le conditionnement, le statut de cycle de vie, les prix et la disponibilité pour déterminer le meilleur composant pour vos exigences de conception.
Texas Instruments
SN65HVD77D - 3.3V 50Mbps Full-Duplex RS-485 | Texas Instruments
SN65HVD77D ✓ ActifComparaison des spécifications
| Paramètre | SN65HVD12D | SN65HVD77D |
|---|---|---|
| Marque | Texas Instruments | Texas Instruments |
| Catégorie | RS-485/RS-422 | Interface ICs |
| Statut du cycle de vie | Actif | Actif |
| Product Type | Differential RS-422/RS-485 transceiver | Full-duplex RS-485 transceiver |
| Tension d'alimentation | 3.3 V | — |
| Duplex Mode | Half-duplex | Full duplex |
| Supported Standards | ANSI TIA/EIA-485-A and ISO 8482:1993 | RS-485 and RS-422 |
| Maximum Signaling Rate | 1 Mbit/s | — |
| Driver Configuration | 3-state differential line driver | — |
| Receiver Configuration | Differential line receiver | — |
| Transmitters per Device | 1 | — |
| Receivers per Device | 1 | — |
| Bus-Pin ESD Protection | Exceeds 16 kV HBM | — |
| Unit-Load Option | 1/8 unit load, up to 256 nodes | — |
| Plage de température de fonctionnement | -40°C to +85°C | -40°C to 125°C |
| Boîtier | 8-pin SOIC | 8-pin SOIC (D) |
| Type de montage | Surface mount | Surface mount |
| Signal Type | Balanced differential | — |
| Power-Supply Architecture | Single supply | — |
| Statut RoHS | [DATA_NEEDED: RoHS status] | Compliant |
| REACH Status | [DATA_NEEDED: REACH status] | — |
| AEC-Q100 Qualification | [DATA_NEEDED: AEC-Q100 qualification status] | — |
| Supply Voltage Range | — | 3.0 V to 3.6 V |
| Nominal Supply Voltage | — | 3.3 V |
| Maximum Data Rate | — | 50 Mbps |
| Number of Drivers | — | 1 |
| Number of Receivers | — | 1 |
| ESD Protection | — | ±12 kV IEC |
| Package Width | — | 3.90 mm |
| External Enable Controls | — | None |
| Driver Output Type | — | Differential |
| Receiver Output Type | — | Single-ended logic output |
| Low-Power Standby Current | — | Less than 5 µA when driver and receiver are disabled |
| Termination Requirement | — | External termination required |