NE5532P vs NE5532AN Comparaison
Comparaison détaillée côte à côte de NE5532P par Texas Instruments et NE5532AN par onsemi. Comparez les spécifications clés, les paramètres électriques, le conditionnement, le statut de cycle de vie, les prix et la disponibilité pour déterminer le meilleur composant pour vos exigences de conception.
Comparaison des spécifications
| Paramètre | NE5532P | NE5532AN |
|---|---|---|
| Marque | Texas Instruments | onsemi |
| Catégorie | Amplifier ICs | Amplifier ICs |
| Statut du cycle de vie | Actif | Actif |
| Amplifier Count | 2 amplifiers | 2 amplifiers |
| Product Type | Dual low-noise operational amplifier | Dual low-noise operational amplifier |
| Maximum Supply Voltage | 30 V | — |
| Supply Voltage Range | ±5 V to ±15 V | — |
| Unity-Gain Bandwidth | 10 MHz typical | — |
| Slew Rate | 9 V/µs typical | [DATA_NEEDED: slew rate] |
| Equivalent Input Noise Voltage | 5 nV/√Hz typical at 1 kHz | — |
| Common-Mode Rejection Ratio | 100 dB typical | — |
| High DC Voltage Gain | 100 V/mV typical | — |
| Peak-to-Peak Output Voltage Swing | 32 V typical with VCC = ±18 V and RL = 600 ohm | — |
| Input Offset Voltage | 4000 µV maximum | [DATA_NEEDED: input offset voltage] |
| Process Technology | Bipolar | — |
| Boîtier | 8-pin PDIP (P) | 8-DIP, 0.300 inch (7.62 mm) |
| Type de montage | Through hole | Through-hole |
| Température de fonctionnement | 0 °C to 70 °C | — |
| Primary Application | Audio | — |
| Statut RoHS | [DATA_NEEDED: RoHS status] | [DATA_NEEDED: RoHS status] |
| REACH Status | [DATA_NEEDED: REACH status] | [DATA_NEEDED: REACH status] |
| Compensation | — | Internally compensated |
| Gain-Bandwidth Product | — | 10 MHz |
| Supported Supply Voltage | — | ±5 V to ±15 V |
| NE5532x Commercial Temperature Range | — | 0°C to 70°C |
| SA5532x Industrial Temperature Range | — | -40°C to +85°C |
| Input Noise Density | — | [DATA_NEEDED: input noise density] |
| Input Bias Current | — | [DATA_NEEDED: input bias current] |
| Output Voltage Swing | — | [DATA_NEEDED: output voltage swing] |
| Output Current | — | [DATA_NEEDED: output current] |
| Total Harmonic Distortion | — | [DATA_NEEDED: total harmonic distortion] |