SN65HVD232DR vs SN65HVD234DR Comparaison
Comparaison détaillée côte à côte de SN65HVD232DR par Texas Instruments et SN65HVD234DR par Texas Instruments. Comparez les spécifications clés, les paramètres électriques, le conditionnement, le statut de cycle de vie, les prix et la disponibilité pour déterminer le meilleur composant pour vos exigences de conception.
Texas Instruments
SN65HVD232DR - 3.3V 1Mbps CAN Transceiver | Texas Instruments
SN65HVD232DR ✓ ActifTexas Instruments
SN65HVD234DR - 3.3V CAN Transceiver 1Mbps w/ Sleep | Texas Instruments
SN65HVD234DR ✓ ActifComparaison des spécifications
| Paramètre | SN65HVD232DR | SN65HVD234DR |
|---|---|---|
| Marque | Texas Instruments | Texas Instruments |
| Catégorie | Interface ICs | Interface ICs |
| Statut du cycle de vie | Actif | Actif |
| Statut du stock | In Stock | In Stock |
| Prix unitaire (USD) | $0,00 | $1,30 |
| Product Type | Single-channel CAN transceiver | CAN Bus Transceiver |
| Tension d'alimentation | 3.3 V | — |
| CAN Data Rate | Up to 1 Mbps | — |
| CAN Standard Compatibility | ISO 11898-2 high-speed CAN physical layer | — |
| Bus Nodes | Up to 120 nodes | — |
| Bus-Pin ESD Protection | Exceeds 16 kV HBM | — |
| Boîtier | 8-pin SOIC | SOIC-8 (D) |
| Température de fonctionnement | -40°C to +85°C | — |
| Supply Voltage Range | [DATA_NEEDED: recommended operating supply-voltage range] | — |
| Logic Input Voltage | [DATA_NEEDED: CAN controller-compatible logic voltage] | — |
| Differential Output Voltage | Comparable between the SN65HVD23x family variants; exact value not stated in verified search data | — |
| Dominant Common-Mode Output | Lower than 5V supplied transceivers by a few hundred millivolts | — |
| Recessive Common-Mode Output Bias | Same as the referenced 5V supplied transceiver family | — |
| Receiver Input Impedance | High; supports up to 120 nodes on a bus | — |
| Driver Output Transition Time | Controlled for improved signal quality | — |
| Unpowered Node Behavior | Does not disturb the CAN bus | — |
| Channel Count | 1 CAN channel | — |
| Statut RoHS | [DATA_NEEDED: RoHS status for this specific orderable part] | Compliant |
| REACH Status | [DATA_NEEDED: REACH status for this specific orderable part] | — |
| AEC-Q100 Qualification | [DATA_NEEDED: automotive qualification status] | — |
| Protocol | — | ISO 11898-1 CAN 2.0A/B |
| Supply Voltage (VCC) | — | 3.0 V to 3.6 V |
| Logic Supply Voltage (VIO) | — | Not required (3.3V logic) |
| Maximum Signaling Rate | — | 1 Mbps |
| Number of Drivers/Receivers | — | 1/1 |
| Bus Fault Protection | — | +/-36 V |
| ESD Protection (Bus Pins, HBM) | — | >16 kV |
| Common-Mode Input Range | — | +/-12 V (extended) |
| Maximum Nodes Supported | — | 120 |
| I/O Logic Level | — | LVTTL, 5V-tolerant |
| Sleep Mode Supply Current | — | 0.05 uA (typical) |
| Standby Mode Supply Current | — | 370 uA (typical) |
| Plage de température de fonctionnement | — | -40C to +125C |
| Type de montage | — | Surface Mount |
| Modes of Operation (RS Pin) | — | High-speed, Slope Control, Low-power Standby |
| Dominant Time-Out Protection | — | Yes |
| Arrêt thermique | — | Yes |