SN65HVD51D vs SN65HVD53D Comparaison

Comparaison détaillée côte à côte de SN65HVD51D par Texas Instruments et SN65HVD53D par Texas Instruments. Comparez les spécifications clés, les paramètres électriques, le conditionnement, le statut de cycle de vie, les prix et la disponibilité pour déterminer le meilleur composant pour vos exigences de conception.

Comparaison des spécifications

Paramètre SN65HVD51D SN65HVD53D
Marque Texas Instruments Texas Instruments
Catégorie Interface ICs Interface ICs
Statut du cycle de vie Actif Actif
Product Type RS-422/RS-485 full-duplex transceiver —
Driver Count 1 driver —
Receiver Count 1 receiver —
Maximum Signaling Rate 5 Mbps —
Supply Voltage Range 4.5 V to 5.5 V [DATA_NEEDED: supply voltage range]
Interface Standards RS-422 and RS-485 —
Duplex Mode Full-duplex —
Receiver Unit Load 1/8 unit load —
Maximum Bus Nodes Up to 256 nodes —
Bus-Pin ESD Protection Exceeds 15 kV HBM —
Available Driver Transition Rates 1 Mbps, 5 Mbps, and 25 Mbps —
Standby Current Less than 1 µA 1 uA (both driver and receiver disabled)
Plage de température de fonctionnement -40 °C to 85 °C -40 C to +85 C
Boîtier 8-pin SOIC (D) SOIC (D), 14 pins, 3.90 mm width, 0.154 inch pitch
Type de montage Surface mount Surface mount
Enable Architecture Fully enabled; no external enable pins —
Statut RoHS [DATA_NEEDED: RoHS compliance status] [DATA_NEEDED: RoHS status]
REACH Status [DATA_NEEDED: REACH compliance status] —
Device Type — Full-duplex RS-485 / RS-422 transceiver with enables
Number of Drivers / Receivers — 1 / 1
Driver Enable Polarity — Active-high
Receiver Enable Polarity — Active-low
Unit Load Option — 1/8 unit-load option available (up to 256 nodes on the bus)
Maximum Nodes on Bus — 256 nodes
Bus Pin ESD Protection — Exceeds 15 kV HBM
Driver Output Transition Time Options — 1 Mbps, 5 Mbps and 25 Mbps signaling rates
Receiver Output — Glitch-free
Standards Supported — RS-485, RS-422
Maximum Data Rate (this device) — [DATA_NEEDED: maximum data rate for SN65HVD53D]
Driver Output Current — [DATA_NEEDED: high-output driver current]
Receiver Sensitivity — [DATA_NEEDED: receiver input sensitivity]

Fiches techniques et ressources

Parcourir tous les produits Créer un BOM Demander un devis