SP485E vs MAX485CPA+ Comparaison
Comparaison détaillée côte à côte de SP485E par MaxLinear et MAX485CPA+ par Analog Devices. Comparez les spécifications clés, les paramètres électriques, le conditionnement, le statut de cycle de vie, les prix et la disponibilité pour déterminer le meilleur composant pour vos exigences de conception.
MaxLinear
SP485E - Enhanced Low Power Half-Duplex RS-485/RS-422 Transceiver | MaxLinear
SP485E ✓ Actif
Comparaison des spécifications
| Paramètre | SP485E | MAX485CPA+ |
|---|---|---|
| Marque | MaxLinear | Analog Devices |
| Catégorie | Interface ICs | Interface ICs |
| Statut du cycle de vie | Actif | Actif |
| Fonction | Transceiver | — |
| Protocol | RS-485, RS-422 | — |
| Number of Drivers/Receivers | 1/1 | — |
| Duplex | Half-duplex | — |
| Débit de données | 2.5 Mbps (max, SP485E non-slew-limited) | — |
| Supply Voltage (VCC) | 4.75 V to 5.25 V | — |
| Receiver Input Sensitivity | ±200 mV | — |
| Receiver Input Impedance | 12 kΩ minimum, 15 kΩ typical | [DATA_NEEDED: receiver input impedance] |
| Common-Mode Range | −7 V to +12 V | — |
| ESD Protection (HBM) | ±15 kV | — |
| ESD Protection (IEC 61000-4-2 Air Discharge) | ±15 kV | — |
| Plage de température de fonctionnement | [DATA_NEEDED: operating temperature] | [DATA_NEEDED: operating temperature range] |
| Boîtier | 8-pin NSOIC or PDIP | 8-pin PDIP |
| Type de montage | Surface Mount (NSOIC) or Through-Hole (PDIP) | Through-hole |
| Process Technology | BiCMOS | — |
| Failsafe Receiver | Yes (open, shorted, idle bus) | — |
| Tri-State Enable Pins | Yes (DE, RE) | — |
| Statut RoHS | Compliant | unknown |
| Product Type | — | RS-485/RS-422 low-power transceiver |
| Driver Count | — | 1 |
| Receiver Count | — | 1 |
| Communication Mode | — | Half-duplex |
| Supported Standards | — | RS-485 and RS-422 |
| Signal Type | — | Differential |
| Slew Rate | — | Slew-rate-limited |
| Tension d'alimentation | — | [DATA_NEEDED: supply voltage] |
| Maximum Data Rate | — | [DATA_NEEDED: maximum data rate] |
| Driver Output Current | — | [DATA_NEEDED: driver output current] |
| Common-Mode Voltage Range | — | [DATA_NEEDED: common-mode voltage range] |
| Quiescent Supply Current | — | [DATA_NEEDED: quiescent supply current] |
| REACH Status | — | unknown |
| AEC-Q100 Qualification | — | unknown |
| Lead-Free Status | — | unknown |