PCM1773RGA
PCM1773RGA - 24-Bit Stereo Audio DAC | Texas Instruments
The Texas Instruments PCM1773RGA is a low-voltage, low-power stereo audio digital-to-analog converter with an integrated line-out amplifier and hardware control. It supports two-channel, 24-bit audio at up to 50 kHz through an I2S interface, provides 98 dB signal-to-noise ratio, and is packaged in a 20-pin VQFN (RGA) measuring 4.2 mm by 4.2 mm. Its combination of a delta-sigma DAC, integrated line output stage, and compact surface-mount package makes it suitable for compact audio systems.
A stereo audio DAC converts digital PCM samples into left- and right-channel analog voltages. The PCM1773RGA integrates that conversion function with line-out circuitry, reducing the number of external components required in typical audio signal paths. An I2S-compatible digital interface connects the converter to an audio processor, decoder, or digital audio source, while the integrated line-output stage provides an analog output suitable for subsequent voltage amplification or line-level routing.
The principal performance characteristics are 24-bit conversion resolution, 50 kHz maximum sampling performance, 98 dB SNR, and support for two audio channels. The manufacturer identifies the device as a low-voltage, low-power stereo DAC with hardware line-output control. Those characteristics place it between basic digital audio interfaces and higher-performance integrated audio converter families, where channel count, converter resolution, output topology, and control requirements determine the appropriate replacement path.
The PCM1773 family uses CMOS integrated circuitry containing stereo digital-to-analog converters, line-out circuitry, and support functions. In this configuration, the digital interface receives serial audio data while the converter reconstructs the analog waveform. The integrated line-output amplifier provides a more direct connection to the next analog stage than a bare converter output, although the exact output configuration, load capability, and gain settings must be confirmed against the manufacturer datasheet before finalizing a board design.
Typical uses include compact stereo audio playback, digital receiver and decoder designs, audio-interface modules, multimedia systems, and line-level analog output stages. The 24-bit interface is suitable for preserving source word depth, while the 98 dB SNR specification provides a clear dynamic-range figure for architecture selection. The 50 kHz sampling limit should be checked against the required source rate; designs operating at higher rates need a different converter family.
PCB planning should place the digital interface, analog outputs, bypass capacitors, and exposed thermal pad according to the manufacturer layout guidance. Maintain the required supply voltage, grounding, and output-load conditions, and account for the exposed pad when defining copper area and thermal relief. Do not assume that a same-package family member is interchangeable without verifying pin functions, control polarity, output configuration, and timing requirements.
This product page consolidates the known 24-bit, two-channel, 50 kHz, 98 dB SNR, I2S, line-out, and VQFN-20 characteristics with practical integration guidance. It also distinguishes documented device facts from engineering details that still require confirmation from the manufacturer datasheet, helping designers move from part selection to a controlled schematic and layout review.
RFQ
צור קשר