ATMEGA329-16AU vs ATMEGA329P-20AU तुलना
विस्तृत दोनों ओर की तुलना ATMEGA329-16AU द्वारा Microchip Technology और ATMEGA329P-20AU द्वारा Microchip Technology. मुख्य विशेषताओं, इलेक्ट्रिकल पैरामीटर, पैकेजिंग, चक्र स्थिति, मूल्यांकन और उपलब्धता को तुलना करके अपनी डिजाइन की आवश्यकताओं के लिए सबसे अच्छा घटक निर्धारित करें。
Microchip Technology
ATMEGA329-16AU - 8-bit AVR MCU 16MHz 32KB Flash LCD | Microchip
ATMEGA329-16AU ✓ सक्रियMicrochip Technology
ATMEGA329P-20AU - 20MHz 8-bit AVR MCU 32KB Flash TQFP-64
ATMEGA329P-20AU ✓ सक्रियविशेषता तुलना
| पैरामीटर | ATMEGA329-16AU | ATMEGA329P-20AU |
|---|---|---|
| ब्रांड | Microchip Technology | Microchip Technology |
| श्रेणी | Microcontrollers | Microcontrollers |
| लाइफसाइकिल स्थिति | सक्रिय | सक्रिय |
| Core Architecture | 8-bit AVR RISC | AVR (8-bit RISC, Harvard) |
| अधिकतम क्लॉक फ़्रीक्वेंसी | 16 MHz | — |
| Flash Program Memory | 32 KB (16K x 16) | — |
| EEPROM | 1 KB | 1 KB |
| SRAM | 2 KB | 2 KB (2K x 8) |
| Supply Voltage Range | 4.5 V to 5.5 V | — |
| General Purpose I/O Lines | 54 | — |
| पैकेज | 64-TQFP (14x14 mm), 0.8 mm pitch | 64-pin TQFP (14x14 mm, 0.8 mm pitch) |
| LCD Controller | On-chip segment LCD controller with internal contrast control | — |
| JTAG Interface | Yes (boundary-scan, on-chip debug, programming) | — |
| In-System Programming | Yes (ISP Flash, read-while-write) | — |
| General Purpose Working Registers | 32 | — |
| Instructions | 130+ powerful instructions, most single-clock cycle | — |
| माउंटिंग प्रकार | Surface Mount | Surface Mount |
| Life Cycle Stage | Active | — |
| RoHS स्थिति | [DATA_NEEDED: RoHS status] | Compliant (Pb-free / Green) |
| ऑपरेटिंग तापमान | [DATA_NEEDED: operating temperature range] | -40C to +85C (industrial, -A suffix) |
| Instruction Set | — | 131 instructions, mostly single-cycle |
| Program Memory (Flash) | — | 32 KB (16K x 16), In-System Programmable with RWW |
| Maximum Clock Speed | — | 20 MHz |
| Throughput | — | Up to 20 MIPS at 20 MHz |
| Supply Voltage (Vcc) | — | 2.7 V to 5.5 V (10 MHz max below 4.5 V; 20 MHz requires 4.5-5.5 V) |
| General-Purpose I/O Pins | — | 54 |
| General-Purpose Working Registers | — | 32 |
| ADC | — | 10-bit, up to 8 single-ended channels |
| PWM Channels | — | 6 |
| Communication Peripherals | — | 2x USART, 1x TWI (I2C), 1x SPI (also ISP) |
| Debug Interface | — | JTAG (IEEE 1149.1 compliant) |
| Power-Save Modes | — | Idle, ADC Noise Reduction, Power-save, Power-down, Standby, Extended Standby (picoPower) |
| QTouch Support | — | Yes (peripheral touch controller via library) |