PCA9534PWR vs TCA9554PWR तुलना
विस्तृत दोनों ओर की तुलना PCA9534PWR द्वारा NXP Semiconductors और TCA9554PWR द्वारा Texas Instruments. मुख्य विशेषताओं, इलेक्ट्रिकल पैरामीटर, पैकेजिंग, चक्र स्थिति, मूल्यांकन और उपलब्धता को तुलना करके अपनी डिजाइन की आवश्यकताओं के लिए सबसे अच्छा घटक निर्धारित करें。
NXP Semiconductors
PCA9534PWR - 8-Bit I2C I/O Expander | NXP Semiconductors (Tape & Reel)
PCA9534PWR ✓ सक्रियविशेषता तुलना
| पैरामीटर | PCA9534PWR | TCA9554PWR |
|---|---|---|
| ब्रांड | NXP Semiconductors | Texas Instruments |
| श्रेणी | Interface ICs | Interface ICs |
| लाइफसाइकिल स्थिति | सक्रिय | सक्रिय |
| Device Type | 8-bit CMOS I2C-bus and SMBus low-power I/O port expander | 8-bit I/O expander |
| Number of GPIO Pins | 8 | — |
| Supply Voltage Range | 2.3 V to 5.5 V | 1.65 V to 5.5 V |
| I2C Bus Frequency | 400 kHz | — |
| इंटरफ़ेस | I2C-bus and SMBus | I2C / SMBus |
| Interrupt Output | Yes | Yes |
| Configuration Registers | Yes | Yes |
| Address Configuration Pins | A0, A1, and A2 | — |
| Maximum Devices Sharing Bus | 8 devices per manufacturer data | — |
| Internal I/O Pull-up Resistors | Removed | — |
| पैकेज | 16-pin TSSOP | 16-TSSOP |
| पिन काउंट | 16 pins | 16 pins |
| माउंटिंग प्रकार | Surface Mount | Surface mount |
| PCF8574 Compatibility | Pin-to-pin and I2C address compatible; software changes required | — |
| Manufacturer | NXP Semiconductors | — |
| लाइफसाइकिल स्थिति | Active | — |
| ऑपरेटिंग तापमान | [DATA_NEEDED: operating temperature range] | — |
| RoHS स्थिति | [DATA_NEEDED: RoHS status] | [DATA_NEEDED: RoHS status] |
| REACH Status | [DATA_NEEDED: REACH status] | — |
| I/O Port Count | — | 8 ports |
| Maximum I2C Bus Frequency | — | 400 kHz |
| Weak Pull-Up Configuration | — | Yes |
| Address Inputs | — | A0, A1, A2 |
| Maximum Devices Per Bus | — | 8 devices |
| Reset Behavior | — | Power-on reset to default state |
| Input Port Function | — | 8-bit general-purpose input |
| Output Port Function | — | 8-bit general-purpose output |
| ऑपरेटिंग तापमान रेंज | — | [DATA_NEEDED: operating temperature range] |
| Output Current per Port | — | [DATA_NEEDED: output current per port] |
| Standby Current | — | [DATA_NEEDED: standby current] |