SN65HVD234DR vs SN65HVD230QDRQ1 Perbandingan
Perbandingan bersamaan detil SN65HVD234DR dari Texas Instruments dan SN65HVD230QDRQ1 dari Texas Instruments. Bandingkan spesifikasi penting, parameter listrik, pengemasan, status cycle, harga, dan ketersediaan untuk menentukan komponen terbaik untuk kebutuhan desain Anda.
Texas Instruments
SN65HVD234DR - 3.3V CAN Transceiver 1Mbps w/ Sleep | Texas Instruments
SN65HVD234DR ✓ AktifTexas Instruments
SN65HVD230QDRQ1 - 3.3V CAN Transceiver AEC-Q100 | Texas Instruments
SN65HVD230QDRQ1 ✓ AktifPerbandingan Spesifikasi
| Parameter Umum | SN65HVD234DR | SN65HVD230QDRQ1 |
|---|---|---|
| Merek | Texas Instruments | Texas Instruments |
| Kategori | Interface ICs | Interface ICs |
| Status Lingkungan Hidup | Aktif | Aktif |
| Harga Unit (USD) | $1,30 | $1,11 |
| Product Type | CAN Bus Transceiver | — |
| Protocol | ISO 11898-1 CAN 2.0A/B | — |
| Supply Voltage (VCC) | 3.0 V to 3.6 V | — |
| Logic Supply Voltage (VIO) | Not required (3.3V logic) | — |
| Maximum Signaling Rate | 1 Mbps | — |
| Number of Drivers/Receivers | 1/1 | — |
| Bus Fault Protection | +/-36 V | — |
| ESD Protection (Bus Pins, HBM) | >16 kV | — |
| Common-Mode Input Range | +/-12 V (extended) | — |
| Maximum Nodes Supported | 120 | — |
| I/O Logic Level | LVTTL, 5V-tolerant | — |
| Sleep Mode Supply Current | 0.05 uA (typical) | — |
| Standby Mode Supply Current | 370 uA (typical) | — |
| Rentang Suhu Kerja | -40C to +125C | -40C to +125C |
| Paket | SOIC-8 (D) | 8-SOIC (D), 3.90 mm width |
| Tipe Mounting | Surface Mount | Surface Mount |
| Status RoHS | Compliant | — |
| Modes of Operation (RS Pin) | High-speed, Slope Control, Low-power Standby | — |
| Dominant Time-Out Protection | Yes | — |
| Penutupan Panas | Yes | — |
| Transceiver Type | — | CAN (Half-duplex, 1 driver / 1 receiver) |
| Laju Data | — | Up to 1 Mbps |
| Tegangan Pemuat | — | 3.3 V |
| Standby Mode Current | — | 370 uA (typical) |
| Bus Pin ESD Protection | — | Exceeds 15 kV HBM |
| Device ESD Rating | — | Exceeds 2000 V per MIL-STD-883 |
| Protocol Compatibility | — | ISO 11898-2 High Speed CAN Physical Layer |
| Standby Mode | — | Yes (RS pin controlled) |
| Dominant Timeout | — | Yes |
| Slew Rate Control | — | Yes (RS pin) |
| Unpowered Node Behavior | — | Does not disturb the bus |
| AEC-Q100 Qualification | — | Qualified (Automotive Catalog) |
| Packaging | — | Tape & Reel (DR) |