Microchip MTCH3380P 및 MTCH3240P, 가전 HMI용 12-ADC 병렬 감지 추가

Microchip이 버튼, 슬라이더, 휠용 온칩 병렬 ADC를 갖춘 턴키 터치 컨트롤러 두 종을 출시했으며, 10k 개 기준 $0.80부터 시작합니다.

게시됨 업데이트됨 4 분 소요 ✓ AI 대응 공유

TL;DR — 세 문장

  • Microchip released the MTCH3380P and MTCH3240P as its first turnkey touch controllers with parallel sensing for buttons, sliders, and wheels. (S1)
  • Each part integrates 12 on-chip ADCs running in parallel, supporting up to 64 sensors (MTCH3380P) or 32 sensors (MTCH3240P) in mutual-capacitance mode. (S1)
  • Both devices target IEC/UL 60730 Class B functional safety and 105 °C operation, aimed at ovens, cooktops, EV chargers, parking meters, and kiosks. (S1)

출처: key_takeaways (실제 필드, 최대 3개 항목). 사실과 분석은 별도로 표시됩니다.

Microchip MTCH3380P 및 MTCH3240P, 가전 HMI용 12-ADC 병렬 감지 추가Editorial cover for a component sourcing brief. Power motif; headline "Microchip MTCH3380P 및 MTCH3240P, 가전 HMI용 12-ADC 병렬 감지 추가". No reported key numbers on this brief, so no number strip is drawn. 1 cited source. A one-time entrance animation stops under reduced motion.Microchip MTCH3380P 및 MTCH3240P, 가전 HMI용12-ADC 병렬 감지 추가XAIPART
Cover image generated from data already shown on this page: the category motif, the headline, and reported key numbers. No decorative illustration; no third-party image.

AI 답변을 통해 오셨습니다 — 이것은 검증 가능한 원문입니다

AI 요약은 주장의 근거를 누락했을 수 있습니다. 원래 예측, 영향받는 부품 및 모든 인용은 이 페이지에 있으며 각각 출처로 추적할 수 있습니다.

XAIPART 예측

이 브리프에는 반증 가능한 예측이 포함되어 있습니다.

전체 예측 및 반증 규칙으로 이동 ›
영향받는 부품

이 기사에 대한 카탈로그 일치가 없습니다 — 일치를 추론하지 않고 아무것도 표시하지 않습니다.

판단 기준 보기 ›
부품을 소싱하시겠습니까? 요청 보내기 → RFQ

Reported by Embedded on 2026-10-09. Summarized and analyzed by XAIPART Editorial.

What happened

Microchip Technology Inc. has launched its first turnkey touch controllers with parallel sensing for buttons, sliders, and wheels, targeting appliance and outdoor/industrial human-machine interfaces. S1 The two parts extend the company's capacitive-touch family and are intended to let equipment makers replace displays with illuminated capacitive-touch controls at lower cost.

The new parts are the MTCH3380P and MTCH3240P. S1 Microchip positions them for interfaces that previously needed large sensor counts, which the source says can drive up acquisition time and reduce signal-to-noise ratio (SNR). The controllers address this through parallel acquisition across on-chip ADCs, allowing many buttons, sliders, and wheels to maintain response time and SNR in noisy environments. S1

Each device carries 12 on-chip ADCs operating in parallel. S1 The MTCH3380P supports up to 38 sensors in self-capacitance mode and 64 sensors in mutual-capacitance mode; the MTCH3240P supports up to 24 in self-cap mode and 32 in mutual-cap mode. S1 The devices are specified for IEC/UL 60730 Class B functional safety and operation up to 105 °C, with listed use cases including ovens, cooktops, refrigerators, washing machines, EV chargers, parking meters, and kiosks. S1 Design support covers the mTouch Studio development environment and evaluation hardware with host drivers for Linux and Zephyr. S1

Key numbers
MetricReported valueSource
On-chip ADCs per device12 (parallel)[S1]
MTCH3380P sensor count, self-capUp to 38[S1]
MTCH3380P sensor count, mutual-capUp to 64[S1]
MTCH3240P sensor count, self-capUp to 24[S1]
MTCH3240P sensor count, mutual-capUp to 32[S1]
Operating temperatureUp to 105 °C[S1]
Functional safetyIEC/UL 60730 Class B[S1]
MTCH3380P price (10,000-unit qty)From $1.06 each[S1]
MTCH3240P price (10,000-unit qty)From $0.80 each[S1]

Background timeline

  1. - Microchip launches the MTCH3380P and MTCH3240P turnkey touch controllers with 12 parallel on-chip ADCs; the source did not disclose prior part generations or release dates in the capacitive-turnkey MCU line. [S1]
  2. No prior milestones disclosed by the source.

XAIPART take

Technical impact

Twelve ADCs running in parallel is the headline architecture change: it lets designers scan a full slider, wheel, or button matrix in roughly one conversion cycle, which preserves SNR where traditional sequential-scan parts would need either longer acquisition windows or extra external analog front-end. XAIPART analysis

Self-capacitance vs mutual-capacitance headroom matters for through-glass and glove use cases called out in the release; designers should benchmark wet-condition and glove performance in mutual-cap mode before locking the BOM, because mutual-cap traditionally trades raw sensitivity for noise rejection. XAIPART analysis

Market impact

Both parts are stocked and orderable today at $0.80-$1.06 in 10k quantities, which removes a typical sample-window delay for appliance and EV-charger programs sourcing through distribution. XAIPART analysis

The IEC/UL 60730 Class B claim and 105 °C rating position the MTCH3380P and MTCH3240P against established appliance-touch incumbents in white goods and outdoor HMI; the lower MTCH3240P price point specifically targets cost-down replacements where display stacks can be deleted. XAIPART analysis

Action

Procurement teams building Class-B BOMs for ovens, cooktops, or EV chargers should pull MTCH3380P samples and confirm IEC/UL 60730 certificate numbers and the 105 °C characterization reports directly with Microchip before derisking a socket swap. XAIPART analysis

Design engineers migrating off a sequential-scan touch controller should evaluate the mTouch Studio flow plus the published Linux and Zephyr host drivers on actual stack-up glass or acrylic, including wet and glove matrices, before committing the PCB layout. XAIPART analysis

XAIPART Forecast

XAIPART expects the MTCH3240P quoted $0.80 price in 10k-unit quantities to remain within ±5% at authorized distributors through Q2 2027; if published 10k-unit pricing on the MTCH3240P falls below $0.76 by 2027-06-30, this forecast is wrong. XAIPART analysis

Facts are as reported by the cited source. The design-in, sourcing and forward-looking statements above are XAIPART's analysis, not the source's claims. Uncertainty: IEC/UL 60730 certificate numbers, full datasheet SNR figures in dB, and ADC scan-time specifications were not disclosed by the source.

Corrections: none at publication. This brief will be updated with a timestamp if the source corrects its report.

대체품 및 수명 주기

등록된 대체품 — 카탈로그 범위이며 시장 순위가 아닙니다
부품관계수명 주기근거
— 등록된 대체품 없음 데이터 필요 — 요구 사항 match_type 어떤 전임자 라벨이 표시되기 전에

"전임자" 및 "대체품" 라벨은 기록된 일치 유형, 수명 주기 상태 또는 출처 텍스트에서만 부여됩니다. 일치가 기록되지 않은 경우 라벨이 표시되지 않습니다. 당사 자체 등록 상품은 시장 기준이 아닙니다.

주시할 사항

반증 가능한 예측 — 임계값, 기간 및 현재 상태. 반증된 예측도 계속 표시됩니다.
주장임계값작성:상태
XAIPART expects the MTCH3240P quoted $0.80 price in 10k-unit quantities to remain within ±5% at authorized distributors through Q2 2027 published 10k-unit pricing on the MTCH3240P falls below $0.76 by 2027-06-30 Pending

잘못된 예측도 계속 표시하고 표시를 남깁니다. 삭제하지 않습니다.

영향받는 부품

카탈로그 일치 없음. 이 보도는 현재 XAIPART에 등록된 어떤 부품과도 매핑되지 않습니다. 일치를 추론하지 않으며 자리 표시자 목록도 표시하지 않습니다.

차원별 비용 압력

Source: FRED · Generated · reference output z and composite are algorithm outputs, not a fetch snapshot

Cost pressure by dimension — composite stateDiverging bars for three dimensions around a zero midpoint. Input Cost has no reading; Supply Demand z -1.4711, notable; Fx Energy z 0.2546, neutral. Composite index -9.1, band neutral.0Input costno readingSupply/demandz −1.4711 · notable46 dFX & energyz +0.2546 · neutral5 dcomposite −9.1 · neutral−100 · −40 · −15 · 0 · +15 · +40 · +100
Underlying values — copyable for verification.
DimensionFRED series IDUnitLagAs of
Input costPCOPPUSDM, PALUMUSDM, PNICKUSDMUSD/mt52 d
Supply/demandPCU334413334413, IPG3344Sindex(1982=100) / index(2017=100)46 d
FX & energyDEXCHUS, DCOILBRENTEU, DHHNGSPrate / USD/bbl / USD/MMBtu5 d

No free authoritative interface for: gold · silver · rare earth · polysilicon · lithium carbonate · market share — listed rather than approximated.

이 콘텐츠의 제작 방식

프로세스 증거 — 수집, 출처 온전성, 모델 및 게이트
이 브리프의 감사 추적
Source fetched Embedded · www.embedded.com · 3,051 chars · fetch status success
Source sanity (S1) ok — passed before any model call (no s1_ block recorded)
Model / prompt MiniMax-M3 · prompt Blog Agent - News Summary (v2.8-final) · 6,750 tokens · 30s · run completed
Gate verdict pass · 5/6 applicable checks passed · spec v2.9 · C10 ratio 0.062285 · C10 rounds 0
Time contract 1 <time datetime> values in this brief — 0 violations (+08:00 or date-only)

위의 모든 행은 파이프라인에서 생성되며 수작업으로 작성되지 않습니다.

편집 점수

결정론적 게이트 결과 — 순수 PHP로 판정에 모델이 관여하지 않음
게이트 점수 분석 6 적용 가능한 검사, 5항목 통과: 83 %. No hold items or mandatory failures. Gate spec: v2.9 (S0 + S1 + C1–C20) · Source affinity (C20): 0.7547. 적용 가능한 검사 통과 5 / 6 = 83% · 판정: pass No hold items or mandatory failures Gate spec: v2.9 (S0 + S1 + C1–C20) · Source affinity (C20): 0.7547 게시 여부는 게이트가 결정합니다. 독립 감사 점수는 권고용일 뿐입니다.

관련 보도

오류를 발견하셨습니까? 잘못된 점을 알려 주십시오 — 정정 사항은 원문과 함께 게시되고 기록됩니다. 기사를 조용히 수정하지 않습니다.

댓글

첫 번째 댓글을 남겨 보십시오.

출처

  1. Microchip Adds Parallel Sensing to Touch Controllers — https://www.embedded.com/microchip-adds-parallel-sensing-to-touch-controllers/ · rss · 조회일

사실은 S1/S2로 표시되며 링크된 출처로 추적됩니다. 다음 라벨이 붙은 구절은 분석 는 보도된 사실과 분리되어 유지되는 XAIPART의 자체 추론입니다. 출처 링크는 추정하지 않고 실제로 확인합니다. nofollow — 출처 표기는 의도적입니다.