EPC2T32UCAF48 vs EPC2TC32UCF48 비교

다음의 상세 나란히 비교: EPC2T32UCAF48 제조: Intel 및 EPC2TC32UCF48 제조: Intel. 주요 사양, 전기적 파라미터, 패키징, 수명 주기 상태, 가격 및 재고를 비교하여 설계 요구 사항에 가장 적합한 부품을 결정하십시오.

사양 비교

파라미터 EPC2T32UCAF48 EPC2TC32UCF48
브랜드 Intel Intel
카테고리 Memory ICs Memory ICs
수명 주기 상태 활성 NRND
재고 상태 In Stock In Stock
단가 (USD) $10.05 $10.85
Device Type Configuration PROM for SRAM-based FPGAs —
Memory Capacity 32 Mbit —
인터페이스 Serial / Parallel configuration; JTAG (IEEE 1149.1) ISP —
공급 전압 3.0 V to 3.6 V (3.3 V typical) —
Configuration Modes Serial, Parallel (8/16-bit) —
JTAG Interface 4-wire (TMS, TCK, TDI, TDO) —
Cascade Support Yes (nCASC pin for multi-device chains) —
동작 온도 [DATA_NEEDED: operating temperature range] 0C to +70C (commercial)
패키지 QFP-48 (CAF48) 48-pin TQFP (7x7 mm)
실장 유형 Surface Mount Surface Mount
MSL 레벨 [DATA_NEEDED: MSL rating] [DATA_NEEDED: MSL rating]
RoHS 상태 [DATA_NEEDED: RoHS compliance] [DATA_NEEDED: confirm RoHS compliance]
Process Technology CMOS non-volatile memory —
Manufacturer Intel (formerly Altera) —
Series EPC2 (Enhanced Configuration Device) —
메모리 유형 — Non-volatile configuration PROM (CMOS Flash-based)
Memory Density — 1.6 Mbit (1.6 Mb / 32 Mbit raw)
Memory Configuration — Serial configuration bitstream storage
Supply Voltage (VCC) — 3.0 V to 3.6 V (3.3 V typical)
Supply Voltage (VCCIO) — 1.8 V / 2.5 V / 3.3 V (bank-level)
Output Drive Current (VCCIO) — [DATA_NEEDED: IOH/IOL at 3.3 V VCCIO]
Programming Interface — IEEE Std. 1149.1 JTAG (in-system programmable)
Configuration Interface — Altera serial PROM interface (DCLK, DATA, nCONFIG, nSTATUS, CONF_DONE)
Supported Configuration Modes — FPP, AS, PS, JTAG (mode dependent on target FPGA MSEL pins)
Daisy Chain Support — Yes (multi-device cascade for >16 Mbit FPGAs)
Maximum Cascaded Capacity — Up to 16 Mbit total across chain
Lead Free — [DATA_NEEDED: confirm lead-free]

데이터시트 & 자료

모든 제품 보기 BOM 생성 견적 요청