EPC8QI100 vs EPC8Q1100 비교

다음의 상세 나란히 비교: EPC8QI100 제조: Intel 및 EPC8Q1100 제조: Altera. 주요 사양, 전기적 파라미터, 패키징, 수명 주기 상태, 가격 및 재고를 비교하여 설계 요구 사항에 가장 적합한 부품을 결정하십시오.

사양 비교

파라미터 EPC8QI100 EPC8Q1100
브랜드 Intel Altera
카테고리 Memory ICs FPGA & CPLD
수명 주기 상태 Obsolete 최종 구매
재고 상태 In Stock In Stock
단가 (USD) $10.85 $25.90
메모리 유형 Flash (NOR, Enhanced Configuration PROM) —
메모리 크기 8 Mbit —
Supply Voltage (Core) 3.3 V —
Supply Voltage (I/O) 3.3 V —
인터페이스 Altera FPGA configuration serial/parallel (FPP) + JTAG (IEEE 1149.1) —
In-System Programmability IEEE Std. 1532 compliant —
Programming Language Jam STAPL —
Boundary Scan JTAG boundary-scan test supported —
Data Compression Yes (increases effective capacity) —
Configuration Controller On-chip, dedicated to Altera FPGAs —
Initiate-Configuration Pin nINIT_CONF (private JTAG instruction) —
동작 온도 -40C to +85C (industrial) -40 C to +85 C (industrial)
패키지 100-PQFP (20 x 14 mm) 100-pin PQFP (plastic quad flat pack)
실장 유형 Surface Mount —
Compatible FPGAs Stratix, Stratix II, APEX II, APEX 20K, Mercury, ACEX 1K, FLEX 10K, Cyclone, Cyclone II, Arria GX, Stratix GX, Stratix II GX —
RoHS 상태 Non-compliant (legacy PQFP, lead-bearing) [DATA_NEEDED: RoHS status]
Product Type — Enhanced Configuration Device (boot PROM)
Memory Density — 8 Mbit (8,388,608 bits)
Supported FPGAs — Altera SRAM-based LUT FPGAs (Cyclone, Stratix, APEX, ACEX, Mercury, Excalibur)
Configuration Interface — Altera Enhanced Config serial interface (DATA, DCLK, nCONFIG, nSTATUS, CONF_DONE)
Max DCLK Frequency — 33 MHz (Fast-mode)
Supply Voltage (VCC) — 3.0 V to 3.6 V
Supply Voltage (VCCIO for FPGA interface) — 1.8 V / 2.5 V / 3.3 V tolerant
Programming Interface — IEEE Std 1149.1 JTAG (ISP) + serial byte-blaster mode
In-System Programmable — Yes
Operating Current (active read) — [DATA_NEEDED: active ICC]
Standby Current — [DATA_NEEDED: ICC standby]
Endurance (program/erase cycles) — [DATA_NEEDED: endurance cycles]
Data Retention — [DATA_NEEDED: data retention years]
Lead-Free — [DATA_NEEDED: lead-free]

데이터시트 & 자료

모든 제품 보기 BOM 생성 견적 요청