ICS570B vs ICS570A 비교
다음의 상세 나란히 비교: ICS570B 제조: Renesas Electronics 및 ICS570A 제조: Renesas Electronics. 주요 사양, 전기적 파라미터, 패키징, 수명 주기 상태, 가격 및 재고를 비교하여 설계 요구 사항에 가장 적합한 부품을 결정하십시오.
사양 비교
| 파라미터 | ICS570B | ICS570A |
|---|---|---|
| 브랜드 | Renesas Electronics | Renesas Electronics |
| 카테고리 | Clock & Timing | Clock & Timing |
| 수명 주기 상태 | Unknown | 활성 |
| Product Type | Fanout distribution, spread-spectrum clock generator and zero-delay buffer | Multiplier and Zero Delay Buffer |
| Clock Generator Architecture | Proprietary analog/digital phase-locked loop | — |
| Maximum Output Clock Frequency | 170 MHz | 170 MHz |
| Recommended Supply Voltage | 3.3 V | — |
| Multiplication Ratios | 0.5x to 32x, 14 selectable ratios | — |
| Maximum Input-to-Output Skew | 300 ps maximum for outputs above 60 MHz | — |
| 패키지 | 8-pin SOIC, 0.154 in (3.90 mm) width | 8-pin SOIC, 0.154 inch body width, 3.90 mm width |
| 실장 유형 | Surface mount | Surface mount |
| Input Duty-Cycle Recovery | Supported | — |
| Fanout Function | Supported | — |
| Spread-Spectrum Clock Generation | Supported | — |
| Output Frequency at 3.3 V | Up to 170 MHz | — |
| 동작 온도 범위 | [DATA_NEEDED: operating temperature range] | — |
| 공급 전류 | [DATA_NEEDED: supply current] | — |
| RoHS 상태 | [DATA_NEEDED: RoHS compliance status] | [DATA_NEEDED: RoHS status] |
| 수명 주기 상태 | [DATA_NEEDED: active or lifecycle phase] | — |
| Termination Condition | 27 ohm termination resistor with 15 pF loads on CLK and CLK/2, typical jitter measurement at 25 C | — |
| Manufacturer | — | Renesas Electronics Corporation |
| Supply Voltage Version | — | 5 V version |
| Multiplier Choices | — | 14 choices from 0.5x to 32x |
| Input-to-Output Skew | — | 300 ps maximum for outputs above 60 MHz |
| Clock Architecture | — | Analog/digital PLL-based zero-delay buffer |
| Output Functions | — | Clock multiplication and fanout distribution |
| Input Clock Duty-Cycle Recovery | — | Supported |
| Lead-Free Package | — | Available for A and B versions |
| Manufacturer Document Identifier | — | 570 datasheet |
| Jitter Measurement Temperature | — | 25 °C |
| Jitter Test Termination | — | 27 ohm termination resistor |
| Jitter Test Load | — | 15 pF on both CLK and CLK/2 |
| REACH Status | — | [DATA_NEEDED: REACH status] |
| AEC-Q100 Status | — | [DATA_NEEDED: AEC-Q100 qualification status] |