INA128PA vs INA129PA 비교
다음의 상세 나란히 비교: INA128PA 제조: Texas Instruments 및 INA129PA 제조: Texas Instruments. 주요 사양, 전기적 파라미터, 패키징, 수명 주기 상태, 가격 및 재고를 비교하여 설계 요구 사항에 가장 적합한 부품을 결정하십시오.
사양 비교
| 파라미터 | INA128PA | INA129PA |
|---|---|---|
| 브랜드 | Texas Instruments | Texas Instruments |
| 카테고리 | Amplifier ICs | Amplifier ICs |
| 수명 주기 상태 | 활성 | 활성 |
| Product Type | Precision instrumentation amplifier | — |
| Architecture | Three-op-amp instrumentation amplifier | — |
| Number of Circuits | 1 circuit | — |
| 패키지 | 8-pin PDIP | 8-pin plastic DIP |
| Common-Mode Rejection Ratio | 130 dB | — |
| Minimum Common-Mode Rejection | 120 dB | — |
| 대기 전류 | 700 µA | [DATA_NEEDED: quiescent current] |
| Maximum Input Offset Voltage | 50 µV | 50 uV |
| Maximum Input Voltage Drift | 0.5 µV/°C | — |
| Maximum Input Bias Current | 5 nA | 5 nA |
| Input Protection | ±40 V | — |
| Supply Range | Up to ±18 V | — |
| Gain Range | 1 to 10,000 | [DATA_NEEDED: gain range] |
| Gain Setting | Single external resistor | — |
| Bandwidth at Gain 100 | 200 kHz | — |
| Green Product | Yes | — |
| Restricted Substances | No Sb/Br | — |
| 동작 온도 | -40°C to +85°C | — |
| 실장 유형 | Through-hole | Through-hole |
| Device Type | — | Precision, low-power instrumentation amplifier |
| Number of Amplifiers | — | 1 circuit |
| Maximum Input Offset Drift | — | 0.5 uV/degC |
| Minimum Common-Mode Rejection Ratio | — | 120 dB |
| Maximum Protected Input Voltage | — | -40 V to +40 V |
| Wide Supply Range | — | Plus or minus 18 V |
| 동작 온도 범위 | — | -40 degC to +85 degC |
| Gain-Setting Resistor | — | 49.4 kilohm |
| Gain Equation | — | [DATA_NEEDED: INA129 gain equation] |
| Gain-Bandwidth Product | — | [DATA_NEEDED: gain-bandwidth product] |
| Slew Rate | — | [DATA_NEEDED: slew rate] |
| Maximum Output Voltage | — | [DATA_NEEDED: maximum output voltage] |
| 최대 출력 전류 | — | [DATA_NEEDED: maximum output current] |
| Input Common-Mode Voltage Range | — | [DATA_NEEDED: input common-mode voltage range] |
| RoHS 상태 | — | [DATA_NEEDED: RoHS status] |
| REACH Status | — | [DATA_NEEDED: REACH status] |
| Lead-Free Status | — | [DATA_NEEDED: lead-free status] |