L272AM vs L272D013TR 비교
다음의 상세 나란히 비교: L272AM 제조: onsemi 및 L272D013TR 제조: STMicroelectronics. 주요 사양, 전기적 파라미터, 패키징, 수명 주기 상태, 가격 및 재고를 비교하여 설계 요구 사항에 가장 적합한 부품을 결정하십시오.
사양 비교
| 파라미터 | L272AM | L272D013TR |
|---|---|---|
| 브랜드 | onsemi | STMicroelectronics |
| 카테고리 | Amplifier ICs | Amplifier ICs |
| 수명 주기 상태 | 활성 | 활성 |
| Product Type | Dual high-power operational amplifier | — |
| Amplifier Channel Count | 2 channels | — |
| 최대 출력 전류 | 0.7 A | — |
| 패키지 | 8-DIP through-hole package | 16-pin SO, 3.90 mm width |
| Manufacturer | onsemi | — |
| Supported Load Type | Low-impedance loads | — |
| Series | L272A | — |
| Input Offset Voltage | [DATA_NEEDED: input offset voltage] | [DATA_NEEDED: input offset voltage] |
| Input Bias Current | [DATA_NEEDED: input bias current] | [DATA_NEEDED: input bias current] |
| Input Offset Current | [DATA_NEEDED: input offset current] | — |
| Supply Voltage Range | [DATA_NEEDED: supply voltage range] | 4 V to 28 V |
| Output Voltage Swing | [DATA_NEEDED: output voltage swing] | — |
| Slew Rate | [DATA_NEEDED: slew rate] | 1 V/µs |
| Gain-Bandwidth Product | [DATA_NEEDED: gain-bandwidth product] | 250 kHz |
| 동작 온도 범위 | [DATA_NEEDED: operating temperature range] | [DATA_NEEDED: operating temperature range] |
| RoHS 상태 | [DATA_NEEDED: RoHS status] | [DATA_NEEDED: RoHS compliance status] |
| REACH Status | [DATA_NEEDED: REACH status] | [DATA_NEEDED: REACH compliance status] |
| AEC-Q100 Qualification | [DATA_NEEDED: AEC-Q100 qualification] | — |
| Amplifier Type | — | Dual power operational amplifier |
| Number of Circuits | — | 2 circuits |
| Output Current | — | 0.7 A maximum per amplifier |
| 실장 유형 | — | Surface mount |
| Application Category | — | General-purpose power amplifier |
| Intended Load | — | Low-impedance loads |
| Output Architecture | — | Power operational amplifier |
| 열 저항 | — | [DATA_NEEDED: package thermal resistance] |
| Open-Loop Gain | — | [DATA_NEEDED: open-loop gain] |
| Input Common-Mode Range | — | [DATA_NEEDED: input common-mode voltage range] |
| Output Swing Voltage | — | [DATA_NEEDED: output swing voltage] |