SN65HVD230DR vs SN65HVD232DR 비교
다음의 상세 나란히 비교: SN65HVD230DR 제조: Texas Instruments 및 SN65HVD232DR 제조: Texas Instruments. 주요 사양, 전기적 파라미터, 패키징, 수명 주기 상태, 가격 및 재고를 비교하여 설계 요구 사항에 가장 적합한 부품을 결정하십시오.
Texas Instruments
SN65HVD230DR - 3.3V CAN Transceiver 1Mbps 8-SOIC | Texas Instruments
SN65HVD230DR ✓ 활성
사양 비교
| 파라미터 | SN65HVD230DR | SN65HVD232DR |
|---|---|---|
| 브랜드 | Texas Instruments | Texas Instruments |
| 카테고리 | Interface ICs | Interface ICs |
| 수명 주기 상태 | 활성 | 활성 |
| 재고 상태 | In Stock | In Stock |
| 단가 (USD) | $0.94 | $0.00 |
| Product Type | CAN Bus Transceiver | Single-channel CAN transceiver |
| Number of Drivers/Receivers | 1/1 | — |
| Protocol | CANbus (ISO 11898-2) | — |
| 공급 전압 | 3 V to 3.6 V (3.3 V nominal) | 3.3 V |
| Maximum Data Rate | 1 Mbps | — |
| Driver/Receiver Configuration | Half-Duplex | — |
| Standby Mode Supply Current | 370 uA typical | — |
| ESD Protection (Bus Pins, HBM) | Exceeds 16 kV | — |
| Maximum Nodes on Bus | 120 nodes | — |
| Receiver Common-Mode Range | -2 V to 7 V | — |
| 동작 온도 | -40C to +85C | -40°C to +85°C |
| 패키지 | 8-SOIC (D) | 8-pin SOIC |
| 실장 유형 | Surface Mount | — |
| RoHS 상태 | Compliant | [DATA_NEEDED: RoHS status for this specific orderable part] |
| RS Pin Function | Slew-rate control via external resistor | — |
| CAN Data Rate | — | Up to 1 Mbps |
| CAN Standard Compatibility | — | ISO 11898-2 high-speed CAN physical layer |
| Bus Nodes | — | Up to 120 nodes |
| Bus-Pin ESD Protection | — | Exceeds 16 kV HBM |
| Supply Voltage Range | — | [DATA_NEEDED: recommended operating supply-voltage range] |
| Logic Input Voltage | — | [DATA_NEEDED: CAN controller-compatible logic voltage] |
| Differential Output Voltage | — | Comparable between the SN65HVD23x family variants; exact value not stated in verified search data |
| Dominant Common-Mode Output | — | Lower than 5V supplied transceivers by a few hundred millivolts |
| Recessive Common-Mode Output Bias | — | Same as the referenced 5V supplied transceiver family |
| Receiver Input Impedance | — | High; supports up to 120 nodes on a bus |
| Driver Output Transition Time | — | Controlled for improved signal quality |
| Unpowered Node Behavior | — | Does not disturb the CAN bus |
| Channel Count | — | 1 CAN channel |
| REACH Status | — | [DATA_NEEDED: REACH status for this specific orderable part] |
| AEC-Q100 Qualification | — | [DATA_NEEDED: automotive qualification status] |