MPXA6115A6T1 vs MPX5100A Pengandingan
Pengandingan Sisi Kiri Sisi Kanan Terperinci MPXA6115A6T1 disebabkan oleh STMicroelectronics dan MPX5100A disebabkan oleh NXP Semiconductors. Bandingkan spesifikasi utama, parameter elektrik, pakej, status kehidupan, harga, dan keupayaan untuk menentukan komponen terbaik untuk keperluan disenjaya anda.
STMicroelectronics
MPXA6115A6T1 - 15-115 kPa Absolute Pressure Sensor | STMicroelectronics
MPXA6115A6T1 ✓ Aktif
Pengandingan Spesifikasi
| Parametr | MPXA6115A6T1 | MPX5100A |
|---|---|---|
| Merek | STMicroelectronics | NXP Semiconductors |
| Kategori | Pressure Sensors | Pressure Sensors |
| Status Lingkungan Hidup | Aktif | Aktif |
| Pressure Type | Absolute | Absolute |
| Operating Pressure Range | 2.18 PSI to 16.68 PSI (15 kPa to 115 kPa) | 15 kPa to 115 kPa (2.18 PSI to 16.68 PSI) |
| Jenis Output | Analog Voltage | Analog, ratiometric |
| Tegangan Output | 0.2 V to 4.7 V (at 5 V supply) | — |
| Tegangan Pemberi Arus | 4.75 V to 5.25 V | 5.0 V (typical) |
| Accuracy | ±1.5% FS | ±2.5% (over compensated temperature range) |
| Port Style | Single horizontal port (axial) | — |
| Kemasan | 8-SMD Gull Wing (SOP 8-surface-mount module) | 6-SIP Module |
| Jenis Pemasangan | Surface Mount | Through-Hole |
| Termination Style | PCB / Gull Wing | — |
| Suhu Operasi | -40 °C to +125 °C | 0 C to +85 C (compensated) |
| Signal Conditioning | On-chip bipolar op-amp + thin-film resistor network | — |
| Temperature Compensation | On-chip, calibrated | — |
| Status RoHS | Compliant (per distributor listings) | Compliant |
| Aras MSL | [DATA_NEEDED: MSL level] | — |
| Output Function | Ratiometric to supply voltage | — |
| Maximum Overload Pressure | — | [DATA_NEEDED: maximum overload pressure] |
| Gambaran Tegangan Output | — | 0.2 V to 4.7 V |
| Sensitivity | — | 45 mV/kPa |
| Full-Scale Span (typical) | — | 4.5 V |
| Arus Pemberi Arus | — | 10 mA (typical) |
| Storage Temperature | — | [DATA_NEEDED: storage temperature] |
| Port Configuration | — | Single port (absolute) |
| Response Time | — | [DATA_NEEDED: response time] |