PCF8574P vs PCF8574NG4 Pengandingan
Pengandingan Sisi Kiri Sisi Kanan Terperinci PCF8574P disebabkan oleh NXP Semiconductors dan PCF8574NG4 disebabkan oleh Texas Instruments. Bandingkan spesifikasi utama, parameter elektrik, pakej, status kehidupan, harga, dan keupayaan untuk menentukan komponen terbaik untuk keperluan disenjaya anda.
Pengandingan Spesifikasi
| Parametr | PCF8574P | PCF8574NG4 |
|---|---|---|
| Merek | NXP Semiconductors | Texas Instruments |
| Kategori | Interface ICs | Interface ICs |
| Status Lingkungan Hidup | Aktif | Aktif |
| Device Type | Remote 8-bit I2C I/O expander with interrupt | 8-bit I/O expander |
| Number of I/O Ports | 8 ports | — |
| Port Width | 8 bits | — |
| Supply Voltage Range | 2.5 V to 6 V | 2.5 V to 6 V |
| I2C Bus Frequency | 100 kHz | — |
| Bus Interface | Two-wire bidirectional I2C-bus | — |
| Serial Clock Pin | SCL | — |
| Serial Data Pin | SDA | — |
| Hardware Address Inputs | 3 inputs | — |
| Interrupt Output | 1 open-drain interrupt output | 1 open-drain interrupt output |
| Port Type | 8 quasi-bidirectional I/O ports | 8-bit quasi-bidirectional |
| Kemasan | 16-pin DIP | 16-DIP (0.300 inch, 7.62 mm) |
| Jenis Pemasangan | Through-hole | Through-hole |
| Gambaran Suhu Operasi | [DATA_NEEDED: operating temperature range] | [DATA_NEEDED: operating temperature range] |
| Maximum Port Output Current | [DATA_NEEDED: maximum port output current] | — |
| I2C Pull-Up Requirement | External pull-up resistors required | — |
| Status RoHS | [DATA_NEEDED: RoHS status] | [DATA_NEEDED: RoHS status] |
| REACH Status | [DATA_NEEDED: REACH status] | [DATA_NEEDED: REACH status] |
| AEC-Q100 Qualification | [DATA_NEEDED: AEC-Q100 qualification status] | — |
| Antaramuka | — | I2C |
| Bus Frequency | — | 100 kHz |
| Number of I/O Lines | — | 8 lines |
| Bus Type | — | Two-line bidirectional |
| Kiraan Pin | — | 16 pins |
| Lead Pitch | — | 7.62 mm |
| Maximum Input Voltage | — | [DATA_NEEDED: maximum input voltage] |
| Arus Dalam Tentera | — | [DATA_NEEDED: quiescent current] |
| Output Sink Current | — | [DATA_NEEDED: output sink current] |