EPC16QC-100T vs EPC8QC100 Karşılaştırma
Ayrıntılı yan yana karşılaştırma EPC16QC-100T tarafından Altera ve EPC8QC100 tarafından AlteraAnahtar özellikleri, elektriksel parametreleri, ambalajı, yaşam döngüsü durumu, fiyatlandırma ve mevcudiyeti karşılaştırarak tasarım gereksinimleriniz için en iyi bileşeni belirleyin.
Özellik Karşılaştırması
| Parametre | EPC16QC-100T | EPC8QC100 |
|---|---|---|
| Marka | Altera | Altera |
| Kategori | Memory ICs | Memory ICs |
| Yaşam Döngüsü Durumu | Obsolete | Obsolete |
| Bellek Türü | Flash Configuration PROM (in-system programmable) | Configuration PROM (Flash-based) |
| Memory Density | 16 Mbit (2 Mbyte) | — |
| Supported FPGA Families | Stratix, APEX II, APEX 20K, Mercury, ACEX 1K, FLEX 10K | — |
| Configuration Data Width | 8-bit or 16-bit (cascaded dual-device mode) | — |
| Configuration Modes | Serial (single device), Parallel (two cascaded devices) | — |
| Data Compression Support | Yes (35% to 55% bitstream reduction typical) | — |
| JTAG / Boundary Scan | IEEE 1149.1 compliant, in-system programmable | — |
| Besleme Gerilimi | 3.3 V | 3.3 V |
| Paket | 100-pin PQFP (20 x 14 mm), 0.65 mm pitch | 100-Pin PQFP (20 x 14 mm) |
| İşletim Sıcaklığı | [DATA_NEEDED: Operating temperature range] | 0C to +70C (Commercial) |
| Cascade Interface | nCE / nOE handshake for multi-device chains | — |
| Programming Interface | JTAG (IEEE 1149.1) and serial | — |
| Endurance | [DATA_NEEDED: Program/erase cycle rating] | — |
| Data Retention | [DATA_NEEDED: Data retention specification] | — |
| RoHS Durumu | unknown | [DATA_NEEDED: RoHS compliance] |
| Lead-Free | unknown | — |
| MSL Seviyesi | [DATA_NEEDED: Moisture sensitivity level] | — |
| Montaj Türü | Surface Mount | Surface Mount |
| Bellek Boyutu | — | 8 Mbit |
| Flash Access Time | — | 90 ns (~10 MHz) |
| Configuration Bus Width | — | 16-bit (DQ[]) |
| Configuration Bandwidth | — | Up to 160 Mbps |
| Decompression Support | — | Yes (Altera proprietary) |
| Supported Configuration Modes | — | FPP, PS, AS (FPGA-dependent) |
| ISP Interface | — | JTAG (IEEE 1149.1) |
| Compatible FPGA Families | — | Stratix, APEX II, APEX 20K, Mercury, ACEX 1K, FLEX 10K |
| Lead Free | — | [DATA_NEEDED: lead-free status] |