EPC1PCB vs EPC1PC8 Karşılaştırma
Ayrıntılı yan yana karşılaştırma EPC1PCB tarafından Intel ve EPC1PC8 tarafından AlteraAnahtar özellikleri, elektriksel parametreleri, ambalajı, yaşam döngüsü durumu, fiyatlandırma ve mevcudiyeti karşılaştırarak tasarım gereksinimleriniz için en iyi bileşeni belirleyin.
Özellik Karşılaştırması
| Parametre | EPC1PCB | EPC1PC8 |
|---|---|---|
| Marka | Intel | Altera |
| Kategori | FPGA & CPLD | Memory ICs |
| Yaşam Döngüsü Durumu | NRND | Obsolete |
| Product Type | Enhanced Configuration Device for SRAM-based FPGAs | — |
| Memory Density | 1 Mbit | — |
| Program Memory Type | Flash (non-volatile) | — |
| Configuration Modes Supported | FPP (Fast Passive Parallel), PS (Passive Serial) | — |
| Supply Voltage VCC | 3.3 V | — |
| I/O Voltage Tolerance | 5.0 V tolerant | — |
| Supported FPGA Families | APEX, FLEX, ACEX, Cyclone, Stratix | — |
| Arayüz | Altera configuration bus (DATA, DCLK, nCONFIG, nSTATUS, CONF_DONE) | — |
| Multi-Device Daisy Chain | Yes (nCASC, nCS pins) | — |
| Programming Interface | JTAG (IEEE 1149.1 boundary scan) | — |
| In-System Programmable | Yes | — |
| Program/Erase Endurance | [DATA_NEEDED: program/erase cycles] | — |
| Data Retention | [DATA_NEEDED: data retention years] | — |
| Paket | PLCC-20 (Plastic Leaded Chip Carrier) | 8-pin PDIP (8-PDIP, 300 mil) |
| Montaj Türü | Surface Mount (socket-compatible) | Through-Hole (THT) |
| RoHS Durumu | [DATA_NEEDED: lead-free/RoHS status] | [DATA_NEEDED: RoHS compliance status] |
| Bellek Türü | — | OTP Configuration PROM (Non-volatile) |
| Bellek Boyutu | — | 1 Mbit (1,048,576 bits) |
| Supply Voltage (VCC) | — | 5.0 V (typical) |
| Configuration Interface | — | Altera proprietary serial (DATA, DCLK, OE, nCS) |
| Programmability | — | One-Time Programmable (OTP) |
| Target FPGAs | — | ACEX 1K, APEX 20K/20KE/20KC, FLEX 10K/10KE/10KA, FLEX 6000/A |
| Pin Pitch | — | 2.54 mm (0.100 in) |
| İşletim Sıcaklığı | — | 0 C to +70 C (commercial) [DATA_NEEDED: full min/max range] |
| Programming Hardware | — | Altera MasterBlaster / ByteBlaster (legacy programmer) |
| Configuration Mode | — | Serial (1-bit data, 1-bit clock) |
| Lead-Free | — | [DATA_NEEDED: lead-free / SnPb plating] |
| MSL Seviyesi | — | [DATA_NEEDED: moisture sensitivity level] |