WM8983GEFL/V - 24-Bit Stereo Audio Codec | Cirrus Logic
MPN: WM8983GEFL/V ✓ Hoạt độngWM8983GEFL/V Tóm tắt
A multimedia CODEC is a mixed-signal semiconductor that converts between digital audio streams and analog microphone, headphone, line, or speaker signals. Its functional hierarchy places the WM8983 among audio interface ICs, within audio codecs and ultimately the broader category of interface ICs. Integrating conversion, analog mixing, and speaker amplification reduces the number of discrete components required in portable audio designs.
The WM8983 provides 24-bit stereo ADCs and 24-bit stereo DACs, with I2S and PCM digital interfaces for connection to a host processor or digital audio bus. Its flexible analog mixing block supports combined playback and voice communication paths. The integrated 1 W speaker drive output allows the codec to drive a small loudspeaker directly, making it useful where a separate headphone amplifier is not required.
The device is supplied in a compact 32-QFN (5x5 mm) package suited to space-constrained handsets, portable media players, personal audio products, and embedded multimedia systems. Its low-power design targets battery-operated equipment where converter efficiency, standby behavior, and analog signal integrity influence both system heat and playback quality.
Typical uses include portable music players, mobile media devices, voice-capable portable electronics, compact speakers, and multifunction personal-audio products. The stereo recording path can capture analog microphone or line-level inputs, while the DAC path and analog mixer provide digital playback, voice monitoring, and direct speaker output within one device.
When laying out a WM8983GEFL/V board, place decoupling capacitors at the supply pins and route analog and digital return currents carefully to prevent codec noise from coupling into microphone or speaker signals. Confirm the exact clocking, digital-interface mode, and exposed-pad connection against the manufacturer datasheet before release.
This page organizes the confirmed WM8983GEFL/V capabilities, package information, sourcing path, and engineering trade-offs for engineers evaluating stereo audio codec implementations. It also distinguishes the documented order-code variants and identifies where a genuine pin-to-pin substitute must be validated rather than assumed.
Bộ thay thế dễ dàng lắp đặt cho WM8983GEFL/V — cùng gói, chân-to-chân tương thích. Các bộ phận yêu cầu hàn PCB bị loại trừ.
Các biến thể trong loạt này
Các mẫu cùng loạt có thể lắp đặt dễ dàng tương thích với WM8983GEFL/V (cùng hình factor và footprint) — khác nhau ở Digital Audio Interface, Package, Product Type.
WM8983GEFL/RV
✅ Drop-InLiên hệ để biết giá
Xem tài liệu →WM8983GEFL
✅ Drop-In📋 Tham chiếu thay thế (không có trong danh mục)
WM8983GEFL/V Tỷ lệ tối đa & tính chất điện
| Product Type | Stereo audio codec with integrated 1 W speaker driver |
| ADC Resolution | 24 bit |
| DAC Resolution | 24 bit |
| ADC Configuration | 2 ADC |
| DAC Configuration | 2 DAC |
| Digital Audio Interface | I2S, PCM |
| Speaker Drive Output | 1 W |
| Channel Configuration | Stereo |
| Hộp | 32-QFN (5x5 mm) |
| Kiểu lắp đặt | Surface mount |
| Product Description | Low-power, high-quality stereo codec for portable multimedia applications |
| Analog Mixing | Flexible analog mixing functions for audio playback and voice communication |
| Digital Interface Format | I2S, PCM |
Hướng dẫn cấu hình chân WM8983GEFL/V 32-qfn (5x5 mm)
Cấu hình chân cho WM8983GEFL/V (32-qfn (5x5 mm) gói). IC số này bao gồm chân GPIO, giao diện truyền thông (UART, SPI, I2C) và chân nguồn. Tham khảo tài liệu thông số kỹ thuật của nhà sản xuất để biết các chức năng chân thay thế và tùy chọn cấu hình. Cực kỳ quan trọng cho thiết kế hệ thống tích hợp và lập trình PCB.
Không có dữ liệu chân cụ thể sẵn có cho WM8983GEFL/V.
Tham khảo: tài liệu kỹ thuật cho cấu hình chân đầy đủ.
Ứng dụng tiêu biểu
WM8983GEFL/V phù hợp cho 6 Áp dụngs: Portable Digital Music Player, Voice-Enabled Mobile Media Device, Compact Bluetooth Speaker Module, Personal Audio Recorder, Digital Photo and Video Camera, Embedded Multimedia Control Panel.
Portable Digital Music Player
The WM8983GEFL/V fits a compact music player that records through two 24-bit ADCs and plays back through two 24-bit DACs. Its I2S and PCM interfaces connect the codec to an application processor, while the analog mixer supports input selection and volume control. The integrated 1 W speaker drive can feed a small internal loudspeaker, reducing the need for a separate output amplifier. Its low-power multimedia positioning is appropriate for battery-operated products, and the 32-QFN (5x5 mm) package preserves board area. Confirm supply-voltage and thermal limits against the manufacturer datasheet before selecting the speaker impedance and enclosure output level.
Được đề xuất
Voice-Enabled Mobile Media Device
The WM8983GEFL/V supports portable products that mix music playback with voice communication. Two 24-bit ADCs capture microphone or line-level input, while the flexible analog mixing functions combine the communication and playback paths. Digital audio is transferred through I2S or PCM to a host processor, and the 1 W speaker output provides direct small-speaker drive. This arrangement can reduce external mixed-signal components in a mobile media design. Signal-routing quality depends on correct mixer configuration, microphone preamplifier settings, and analog return grounding, so use the manufacturer register map and reference circuit during firmware bring-up.
Được đề xuất
Compact Bluetooth Speaker Module
A compact wireless speaker can use the WM8983GEFL/V when the module needs local microphone capture and analog audio conditioning in addition to digital playback. The 24-bit stereo DAC path receives I2S or PCM audio from a wireless audio SoC, while the analog mixer supports voice injection and level adjustment. The integrated 1 W output stage can drive a small enclosure speaker when the verified load, supply voltage, and thermal conditions permit it. Its 32-QFN (5x5 mm) package is well suited to densely populated portable modules. Decouple each supply rail at the pins and keep the exposed pad tied to the prescribed ground layout.
Được đề xuất
Personal Audio Recorder
The WM8983GEFL/V can serve as the audio front end in a portable recorder that captures stereo microphone or line-level signals at 24-bit resolution. Two ADCs provide the stereo inputs, and the flexible analog mixer allows monitoring and gain routing between capture and playback paths. A host processor can configure the codec over its digital control interface and exchange audio using I2S or PCM. Using the same codec for recording and monitoring can simplify signal routing, although the analog mixer still requires careful gain staging to avoid clipping. Validate microphone biasing, input impedance, clocking, and grounding against the manufacturer datasheet.
Được đề xuất
Digital Photo and Video Camera
The WM8983GEFL/V can support audio capture and playback in a compact camera when the product includes a small speaker and microphone. Two 24-bit ADCs handle stereo capture, two 24-bit DACs provide digital-to-analog conversion, and the I2S interface connects to a camera application processor. The analog mixer enables microphone monitoring or voice-insertion paths, while the integrated 1 W driver supplies a small onboard-speaker output. The codec's compact QFN package helps conserve camera-board area. Keep the microphone input away from display and power-converter noise sources, and verify the audio clocking scheme with the host processor design team.
Được đề xuất
Embedded Multimedia Control Panel
An embedded control panel with audio prompts can use the WM8983GEFL/V for playback, recording, and spoken-status feedback. The 24-bit DAC path accepts digital audio from the panel processor over I2S or PCM, while the mixer combines system sounds with voice communication. A 1 W speaker driver supports a compact internal transducer without requiring a separate amplifier in space-constrained hardware. The codec also provides analog inputs for gooseneck microphones or line sources. Because embedded panels often share power with switching regulators and displays, analog ground partitioning and local supply bypassing are essential for maintaining a low-noise audio path.
Được đề xuất
Tóm tắt các sản phẩm được đề xuất
Dữ liệu tham khảo kỹ thuật cho WM8983GEFL/V — so sánh, hướng dẫn thiết kế và thông tin tuân thủ.
Hướng dẫn chọn lựa
So sánh với các sản phẩm thay thế
| Tham số | Sản phẩm này | WM8983GEFL/RV | WM8983GEFL |
|---|---|---|---|
| Package | 32-QFN (5x5 mm) | 32-QFN (5x5 mm) | 32-QFN (5x5 mm) |
| Brand | Cirrus Logic | Cirrus Logic | Cirrus Logic |
| ADC Resolution | 24 bit | 24 bit | 24 bit |
| DAC Resolution | 24 bit | 24 bit | 24 bit |
| Digital Audio Interface | I2S, PCM | I2S, PCM | I2S, PCM |
| ADC Configuration | 2 ADC | 2 ADC | 2 ADC |
| DAC Configuration | 2 DAC | 2 DAC | 2 DAC |
| Speaker Drive Output | 1 W | 1 W | 1 W |
| Analog Mixing | Flexible analog mixing for playback and voice communication | Flexible analog mixing | Flexible analog mixing |
| Target Application | Portable multimedia | Portable multimedia | Portable multimedia |
Bảo phân biệt quan trọng
- Combines stereo conversion, analog mixing, and speaker drive (vsWM8983GEFL/RV)
- Supports both I2S and PCM host interfaces (vsWM8983GEFL)
- Integrated two-channel ADC and two-channel DAC architecture (vsWM8983GEFL/RV)
Ghi chú thiết kế
Follow the manufacturer application circuit for supply bypassing and place the required capacitors immediately beside the relevant WM8983GEFL/V pins. Route analog input and speaker-output signals away from digital clock lines and switching-node copper. The 32-QFN package requires careful escape routing between closely spaced pads, so review the datasheet land pattern and exposed-pad grounding instructions before releasing artwork.
Keep the digital audio bus short, use continuous reference planes beneath clock and data routes, and avoid passing microphone traces beneath or beside high-current switching paths. Apply the manufacturer's clocking scheme consistently across the host processor and codec. A stable master clock and correctly configured I2S word alignment reduce jitter, clicks, and channel-timing errors in the 24-bit data stream.
Do not select the speaker impedance, output power, or analog gain settings without checking the electrical limits in the manufacturer datasheet. Verify the /V and /RV order-code qualifiers before treating either variant as interchangeable, and confirm the exposed-pad connection, supply sequencing, and pin multiplexing in the device documentation. A matching package name alone does not establish a safe functional substitution.
Thông tin tuân thủ
Formal RoHS, REACH, halogen-free, and conflict-minerals declarations were not identified in the accessible product summaries. Confirm the exact orderable MPN with the manufacturer before making a compliance claim.