TEA2095T-1-S30J - Dual LLC SR Controller, 38V | NXP
MPN： TEA2095T-1-S30J ✓ 啟用中TEA2095T-1-S30J 概覽
A synchronous rectifier controller is a specialized power management IC that replaces the output rectifier diodes of a switched-mode power supply with actively driven MOSFETs. Because a MOSFET channel exhibits a far lower voltage drop than a Schottky or fast-recovery diode, SR controllers dramatically reduce conduction losses and raise overall conversion efficiency. In the power-supply hierarchy, the TEA2095T belongs to the family of secondary-side power conversion controllers used alongside LLC resonant converters and other resonant topologies.
The TEA2095T incorporates NXP's adaptive gate drive method, which evaluates the conduction state of the SR MOSFETs cycle by cycle and adjusts gate-drive timing to save the maximum amount of energy at any load. Its two integrated driver stages are dedicated to driving the SR MOSFETs that rectify the outputs of a center-tapped transformer secondary, which is the standard configuration for low-voltage, high-current LLC resonant converters.
Architecturally, the device is a dedicated controller for synchronous rectification on the secondary side of resonant converters. The adaptive algorithm extends SR operation down to light load, where conventional fixed-timing SR controllers would turn the MOSFETs off prematurely, and it guards against reverse current at low load, improving both full-load efficiency and light-load standby power - key requirements of modern energy-efficiency regulations such as those addressed by NXP's GreenChip portfolio.
Typical applications include the secondary side of LLC resonant converters in notebook adapters, server and telecom power supplies, LED TV power boards, and high-density USB-PD fast chargers, wherever a center-tapped secondary with low-output-voltage, high-output-current rectification demands minimal conduction loss.
A key design consideration is correct placement and routing of the SR sense signals; because the controller drives two MOSFETs synchronously with the resonant half-cycle, layout symmetry between the two drive channels and short, low-inductance gate loops are essential to avoid spurious turn-on and to preserve the efficiency benefit at 100 kHz-class resonant frequencies.
This page adds value beyond the manufacturer datasheet by synthesizing distributor pricing, availability, drop-in alternatives, and practical engineering design notes in one place.
According to the NXP TEA2095T product page and distributor listings, pricing starts at approximately $1.0833 (as of 2026-09-13, LCSC), and the part is actively stocked.
直接替換替代品，適用於 TEA2095T-1-S30J — 相同封裝，腳位對腳位相容。需重新設計 PCB 的不同封裝零件不列入。
此系列的變體
與下列產品可直接替換的同系列型號： TEA2095T-1-S30J （相同外形與佔位） — 差異在於 Function, Gate Drive Method, Number of Driver Stages.
TEA2095T/1J
✅ 直接替換📋 參考替代品（不在目錄中）
TEA2095T/TE
✅ 直接替換📋 參考替代品（不在目錄中）
TEA2095T-1-S30J 最大額定值與電氣特性
| 功能 | Synchronous Rectification Controller (Dual SR) |
| 拓撲 | Secondary-side SR for resonant converters (LLC) |
| Supply Voltage Range | 4.75 V to 38 V |
| 供應電流 | 90 uA |
| Number of Driver Stages | 2 (for center-tapped SR MOSFETs) |
| Gate Drive Method | Adaptive gate drive (GreenChip) |
| 工作溫度 | -40C to +125C (TJ) |
| 封裝 / 外殼 | 8-SOIC (0.154in, 3.90mm Width) |
| Supplier Device Package | 8-SO |
| 安裝類型 | Surface Mount |
| Product Family | GreenChip |
| Applications | Switch Mode Power Supplies |
TEA2095T-1-S30J 8-so 腳位配置指南
TEA2095T-1-S30J（8-so 封裝）的腳位配置。 此功率元件具有閘極、汲極與源極端子。對於非極性封裝，請參閱製造商資料表以取得確切的第 1 腳方向與佈局詳細資訊。常見應用包括電源設計、馬達驅動與負載切換。
無詳細腳位定義資料： TEA2095T-1-S30J.
請參閱 資料表 以查看完整腳位配置。
典型應用
TEA2095T-1-S30J 適用於 6 應用s: LLC Resonant Converter Secondary-Side Rectification, Notebook and USB-PD Fast Charger Adapters, Server and Telecom Power Supplies, LED TV and Monitor Power Boards, Industrial Auxiliary and Battery-Charging Power Supplies, High-Density DC-DC Modules and Point-of-Load Front Ends.
LLC Resonant Converter Secondary-Side Rectification
The TEA2095T is purpose-built for synchronous rectification on the secondary side of resonant converters, and its two driver stages map directly onto the center-tapped transformer secondary of a half-bridge or full-bridge LLC converter. With adaptive gate drive, the controller senses the conduction interval of each SR MOSFET cycle by cycle and adjusts turn-on/turn-off timing, so conduction losses that would otherwise be dominated by diode drops (about 0.5 V each) fall to I x Rds(on) levels. In a 12 V / 20 A output this can save several watts of loss; the 4.75 V to 38 V supply range and 90 uA consumption keep control power negligible.
推薦
Notebook and USB-PD Fast Charger Adapters
High-power adapters (65 W to 240 W) universally adopt an LLC stage with a synchronous-rectified secondary to meet CoC Tier 2 and DoE Level VI efficiency limits. The TEA2095T fits this role because its adaptive gate drive maintains high efficiency from full load down to light load, where fixed-timing SR controllers degrade efficiency or risk reverse current. Its 8-SOIC package occupies minimal board area, and the -40C to +125C junction rating tolerates enclosed adapter thermals. Designers pair it with low-Rds(on) 30 V to 60 V SR MOSFETs and verify sense-pin routing for clean half-cycle synchronization.
推薦
Server and Telecom Power Supplies
Server PSUs and telecom rectifiers use LLC resonant front ends whose secondaries are center-tapped and carry tens of amperes; even 100 mV of rectifier drop costs multiple watts. The TEA2095T's dual driver stages rectify both half-cycles synchronously, and its adaptive algorithm protects against reverse current at light load - a critical standby-power requirement in always-on server infrastructure. The 38 V maximum supply accommodates 24 V-rail-derived auxiliary supplies, and the 90 uA quiescent draw supports ORing and housekeeping circuits. Layout symmetry between the two gate channels preserves balance at 100 kHz-class resonant frequencies.
推薦
LED TV and Monitor Power Boards
LED television power boards integrate an LLC resonant converter feeding a center-tapped secondary for the 12 V main rail, and they must meet strict standby-power and average-efficiency regulations. The TEA2095T improves conversion efficiency with its two SR driver stages and adaptive gate drive, reducing rectifier losses relative to Schottky diodes at the 10 A-class 12 V output. Its 8-SOIC package suits the cost- and space-constrained single-board architecture, and the 90 uA supply current helps satisfy sub-100 mW standby budgets when combined with a low-standby primary controller.
推薦
Industrial Auxiliary and Battery-Charging Power Supplies
Industrial 24 V bus systems frequently use LLC or quasi-resonant converters with synchronous secondary rectification for battery chargers and control-rail supplies. The TEA2095T's 4.75 V to 38 V supply range tolerates wide auxiliary-rail excursions common on industrial buses, while the -40C to +125C junction rating covers unconditioned factory-floor and outdoor-cabinet environments. Adaptive gate drive maintains efficiency across the broad load range typical of battery charging, from trickle to bulk phase, avoiding the reverse-current events that fixed-timing SR controllers exhibit near charge completion.
推薦
High-Density DC-DC Modules and Point-of-Load Front Ends
Brick-style and open-frame DC-DC modules operating from 48 V telecom inputs often employ an LLC stage whose low-voltage secondary is center-tapped. The TEA2095T provides both SR gate drives from one 8-SOIC controller, minimizing component count and board area in power-dense modules. Because the controller is secondary-side and self-powered from a 4.75 V to 38 V rail, no optocoupler or primary-side signal is needed for SR timing; the adaptive method derives timing from the SR MOSFET conduction itself, which also makes the module tolerant of burst-mode operation at light load.
推薦
推薦產品摘要
工程參考資料，適用於 TEA2095T-1-S30J — 比較、設計指引及合規資訊。
選型指南
與替代品比較
| 參數 | 本產品 | TEA2095T/1J | TEA2095T/TE |
|---|---|---|---|
| Package | 8-SOIC (3.90 mm) | 8-SOIC - same | 8-SOIC - same |
| Brand | NXP Semiconductors | NXP Semiconductors | NXP Semiconductors |
| Supply Voltage Range | 4.75 V to 38 V | 4.75 V to 38 V | 4.75 V to 38 V |
| Supply Current | 90 uA | 90 uA | 90 uA |
| SR Driver Stages | 2 (dual, center-tapped) | 2 (dual, center-tapped) | 2 (dual, center-tapped) |
| Gate Drive Method | Adaptive (GreenChip) | Adaptive (GreenChip) | Adaptive (GreenChip) |
| Operating Temperature | -40C to +125C (TJ) | -40C to +125C (TJ) | -40C to +125C (TJ) |
| Topology Target | Secondary-side SR of resonant (LLC) converters | Same | Same |
主要差異化特點
- Dual integrated SR driver stages for center-tapped secondaries (對比NCP4305 (onsemi))
- Adaptive gate drive across all loads (對比Fixed-timing SR controllers)
- Wide 4.75 V to 38 V supply with 90 uA consumption (對比TEA2095T/1J)
設計說明
Keep the two SR gate-drive loops short, symmetrical, and low-inductance. Because the TEA2095T drives two MOSFETs synchronously with the resonant half-cycles, mismatched trace lengths between the controller and the two SR MOSFETs introduce timing skew that degrades efficiency at light load and can cause spurious turn-on. Route the sense/supply traces away from the gate traces, and use a solid ground plane under the controller to return gate-drive current with minimal loop area.
The controller accepts 4.75 V to 38 V on its supply pin with only 90 uA consumption, but verify the auxiliary rail stays within range during all transients, including output short-circuit and startup bursts. Feed the controller from a small ceramic decoupling capacitor (typ. 100 nF) placed directly at the 8-SOIC supply pin, supplemented by bulk capacitance, to prevent supply dips during gate-charge delivery to the two SR MOSFETs.
Do not substitute cross-brand single-channel SR controllers (e.g., onsemi NCP4305, TI UCC24610, STMicroelectronics SRK2001) onto a TEA2095T footprint: they have different packages, pinouts, and only one driver channel, so a redesign is mandatory. Similarly, when selecting TEA2095T orderable suffixes, confirm the exact suffix (e.g., /1/S30J vs /1J) against the NXP ordering information, as suffixes encode package and packing differences that affect tape-and-reel quantity and footprint availability.
合規資訊
Compliance details were not present in the provided verified web data. Confirm RoHS/REACH status on the NXP product page (nxp.com/part/TEA2095T) before procurement.
