BTS3028SDRATMA1 vs BTS3125TFATMA1 对比
详细并排对比 BTS3028SDRATMA1 出自 Infineon 和 BTS3125TFATMA1 出自 Infineon。对比关键规格、电气参数、封装、生命周期状态、价格和供货情况，以确定最适合您设计需求的元器件。
规格对比
| 参数 | BTS3028SDRATMA1 | BTS3125TFATMA1 |
|---|---|---|
| 品牌 | Infineon | Infineon |
| 分类 | Power MOSFET Drivers | Power MOSFET Drivers |
| 生命周期状态 | 有效 | 有效 |
| 库存状态 | 有库存 | 有库存 |
| 单价（USD） | $0.92 | $0.54 |
| Product Type | Smart Low-Side Power Switch | Single-channel N-channel low-side smart power switch |
| 拓扑 | 1:1 N-Channel, single channel | — |
| 输出电流（最大） | 5 A | — |
| On-Resistance RDS(ON) | 28 mΩ (typ.) | — |
| Load Voltage (max) | 60 V (load-dump rated) | — |
| 工作电源电压 | 5 V to 28 V (typ. 13.5 V) | — |
| Logic Input Voltage (IN) | Logic-level, 3.3 V/5 V compatible | — |
| 封装 | PG-TO252-3-11 (DPAK, 3 pins = 2 leads + tab) | PG-TO252-3-313 (DPAK, SC-63) |
| 安装类型 | Surface Mount | Surface Mount |
| 工作温度 | -40 °C to +150 °C (junction) | — |
| Protection Features | Overtemperature shutdown, overvoltage clamp, ESD, short-circuit current limit, reverse battery, ground loss | — |
| Status Output | Open-drain diagnostic flag | — |
| Automotive Qualification | AEC-Q100 | — |
| RoHS 状态 | Compliant | Compliant |
| MSL 等级 | [DATA_NEEDED: MSL rating] | [DATA_NEEDED: MSL moisture sensitivity level] |
| Load Current (continuous) | — | 2 A |
| Load Current (pulsed) | — | [DATA_NEEDED: pulsed drain current limit] |
| RDS(on) typical | — | 250 mΩ at 5 V Vbb |
| Supply Voltage (Vbb, nominal) | — | 5 V |
| Supply Voltage (Vbb, operating) | — | 5 V to 28 V |
| Load Dump Transient Protection | — | 40 V |
| Input Logic Compatibility | — | 3.3 V / 5 V CMOS |
| On-State Resistance (max) | — | [DATA_NEEDED: maximum RDS(on) over temp] |
| 热阻，结到环境 | — | [DATA_NEEDED: theta_JA value] |
| 工作温度范围 | — | -40°C to +150°C |
| Over-temperature Shutdown | — | ~150°C with auto-restart |
| Short-Circuit Protection | — | Yes, current-limited |
| Over-voltage Protection | — | Yes (clamping at 40 V) |
| ESD Protection | — | Yes (per IEC 61000-4-2, [DATA_NEEDED: contact/air kV rating]) |
| Status Flag Output | — | Yes (fault feedback) |