MC9S08EL32CTL
MC9S08EL32CTL - 40MHz 32KB 8-Bit MCU | NXP
The NXP Semiconductors MC9S08EL32CTL is an 8-bit HCS08 microcontroller operating at up to 40 MHz, with 32 KB of flash memory, 1 KB of RAM, and 512 bytes of EEPROM in a 28-pin TSSOP package. The device includes 22 I/O lines and integrates I²C, LIN bus, SCI, SPI, ADC, PWM, watchdog timer, low-voltage detection, and power-on reset functions.
An HCS08 microcontroller is an embedded-control semiconductor combining a CPU core, program and data memory, peripheral interfaces, and general-purpose I/O in one package. The MC9S08EL32 belongs to the S08EL family, a cost-sensitive 8-bit MCU platform intended for automotive, industrial, consumer, and LIN-connected products. Its LIN controller, also called the Slave LIN Interface Controller or SLIC, is particularly useful in distributed systems where a microcontroller communicates with a vehicle or equipment LIN network.
The combination of 32 KB flash, 1 KB RAM, and 512 bytes of EEPROM provides enough memory for compact embedded control programs without an external memory device. Flash supports in-system programming, while EEPROM preserves calibration, configuration, or serial-number data when power is removed. The 40 MHz maximum clock rate supports responsive control loops and communication handling across the S08 peripheral set.
The MC9S08EL32CTL integrates serial interfaces for I²C, LIN, SCI, and SPI communication. It also provides analog-to-digital conversion, PWM generation, a watchdog timer, low-voltage detection, and power-on reset. These resources allow a compact control design to combine sensor acquisition, actuator timing, and network communication without requiring several separate interface ICs.
Typical uses include LIN slave nodes, automotive body and comfort modules, appliance controls, industrial interface controllers, sensor hubs, and compact motor-control systems. In a LIN design, the dedicated SLIC reduces firmware and external-interface overhead compared with implementing the LIN physical layer separately. The device can also serve as a general-purpose embedded controller when designers need a deterministic 8-bit platform with moderate flash capacity.
PCB design should preserve the 28-pin TSSOP footprint and route the power, ground, reset, clock, and communication pins according to the NXP pin-description table. Decoupling must be placed close to the supply pins, while exposed programming and debug functions should be brought out when production testing or field updates are required. Because the device is marked NRND, new designs should verify roadmap availability before committing to the MCU.
This product record combines the manufacturer's device specifications, lifecycle status, interface capabilities, package details, and practical design guidance. It also distinguishes genuine drop-in candidates from electrically similar parts that lack the original MCU's LIN controller or EEPROM resources, helping engineers evaluate PCB reuse without relying on headline clock-speed comparisons alone.
RFQ
Contact