SN65HVD10D vs SN65HVD77D Comparison
Detailed side-by-side comparison of SN65HVD10D by Texas Instruments and SN65HVD77D by Texas Instruments. Compare key specifications, electrical parameters, packaging, lifecycle status, pricing, and availability to determine the best component for your design requirements.
Texas Instruments
SN65HVD10D - 3.3V RS-485 Transceiver 32Mbps | Texas Instruments
SN65HVD10D ✓ ActiveTexas Instruments
SN65HVD77D - 3.3V 50Mbps Full-Duplex RS-485 | Texas Instruments
SN65HVD77D ✓ ActiveSpecification Comparison
| Parameter | SN65HVD10D | SN65HVD77D |
|---|---|---|
| Brand | Texas Instruments | Texas Instruments |
| Category | Interface ICs | Interface ICs |
| Lifecycle Status | Active | Active |
| Device Type | Half-duplex RS-485 / RS-422 transceiver (1/1) | — |
| Supply Voltage | 3.3 V (single supply) | — |
| Maximum Data Rate | 32 Mbps | 50 Mbps |
| Package | 8-pin SOIC (D package) | 8-pin SOIC (D) |
| Mounting Type | Surface Mount | Surface mount |
| Bus-Pin ESD Protection | Exceeds 16 kV HBM | — |
| Standards Compliance | ANSI TIA/EIA-485-A, ISO 8482:1993 | — |
| Driver Output | 3-state differential line driver | — |
| Receiver Output | Differential input line receiver, single-ended logic output | — |
| Unit Load | [DATA_NEEDED: unit load / maximum node count for SN65HVD10] | — |
| Bus-Fault Protection | 5 A typical (family feature per distributor datasheet listing) | — |
| Operating Temperature Range | -55 °C to +125 °C (per distributor listing; commercial-grade range per TI datasheet) | -40°C to 125°C |
| Logic Levels | 3.3 V CMOS-compatible | — |
| Number of Transceivers | 1 | — |
| RoHS Status | [DATA_NEEDED: RoHS statement for this part number] | Compliant |
| MSL Level | MSL 1 | — |
| Pricing Reference | From $1.4594 (LCSC) as of 2026-10-30 | — |
| Product Type | — | Full-duplex RS-485 transceiver |
| Supply Voltage Range | — | 3.0 V to 3.6 V |
| Nominal Supply Voltage | — | 3.3 V |
| Number of Drivers | — | 1 |
| Number of Receivers | — | 1 |
| Duplex Mode | — | Full duplex |
| Supported Standards | — | RS-485 and RS-422 |
| ESD Protection | — | ±12 kV IEC |
| Package Width | — | 3.90 mm |
| External Enable Controls | — | None |
| Driver Output Type | — | Differential |
| Receiver Output Type | — | Single-ended logic output |
| Low-Power Standby Current | — | Less than 5 µA when driver and receiver are disabled |
| Termination Requirement | — | External termination required |